LH1532FP_13 Datasheet, PDF (1/6 Pages) Vishay Siliconix – Dual 1 Form A Solid-State Relay

www.vishay.com
LH1532FP, LH1532FPTR
Vishay Semiconductors
Dual 1 Form A Solid-State Relay
i179050-1
1
8 _S1
2
7 _S1'
3
6 _S2
4
5
S2'
DESCRIPTION
The LH1532FP is a dual 1 form A (SPST) which can replace
electromechanical relays in many applications. They are
constructed using a GaAlAs LED for activation control and
an integrated monolithic die for the switch output. The die is
comprised of a photodiode array, switch control circuity and
MOSFET switches. The SSR features low on-resistance,
high breakdown voltage and current-limit circuitry that
protects the relay from telephone line induced lightning
surges.
AGENCY APPROVALS
• UL1577, file no. E52744 system code O
• DIN EN 60747-5-5 (VDE 0884)
• FIMKO approval
• CQC GB4943.1-2011 (suitable for installation altitude
below 2000 m)
FEATURES
• Solid-state relay (equivalent to AQW210S)
- Typical R_ON 20 
- Load voltage 350 V
- Load current 120 mA
- Current limit protection
- High surge capability
- Clean bounce free switching
- Low power consumption
- High reliability monolithic receptor
• Two independent relays in a single package
• Package - flat pak
• Isolation test voltage, 3000 V_RMS
• Material categorization: For definitions of compliance
please see www.vishay.com/doc?99912
APPLICATIONS
• General telecom switching
- On/off hook control
- Ring relay
- Ground start
• Industrial controls
- Triac predriver
- Output modules
• Peripherals
- Transducer driver
• Instrumentation
- Automatic tuning/balancing
- Flying capacitor
- Analog multiplexing
Note
• See “solid-state relays” (application note 56)
ORDERING INFORMATION
L
H
1
5
3
2
F
P
T
R
SMD-#
PART NUMBER
PACKAGE
SOP-8, tubes
SOP-8, tape and reel
PACKAGE
CONFIG.
TAPE AND
REEL
UL, FIMKO
LH1532FP
LH1532FPTR
7 mm
Rev. 1.7, 12-Apr-13
1
Document Number: 83830
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000