CRCW01005E3 Datasheet, PDF (1/4 Pages) Vishay Siliconix – Standard Thick Film Chip Resistors

www.vishay.com
CRCW01005 e3
Vishay
Standard Thick Film Chip Resistors
FEATURES
• Very small standard size (0.4 mm x 0.2 mm)
• Low tolerance (1 %)
• Material categorization:
For definitions of compliance please see
www.vishay.com/doc?99912
STANDARD ELECTRICAL SPECIFICATIONS
TYPE
CASE
CASE POWER RATING
SIZE
SIZE
P₇₀
IMPERIAL METRIC
W
LIMITING
ELEMENT
VOLTAGE
U_max.
AC_RMS/DC
V
TEMPERATURE
COEFFICIENT
ppm/K
TOLERANCE
%
RESISTANCE
RANGE

SERIES
CRCW01005 01005 RR0402M
0.031
±1
E24; E96
± 250
10.0 to 1M
± 2, ± 5
E24
15
±1
1.0 to 9.76 E24; E96
-200/+600
± 2, ± 5
1.0 to 9.1
E24
Zero-Ohm-Resistor: R_max. = 50 m, I_max. = 0.5 A
Notes
• These resistors do not feature a limited lifetime when operated within the permissible limits. However, resistance value drift increasing over
operating time may result in exceeding a limit acceptable to the specific application, thereby establishing a functional lifetime.
• Power rating depends on the max. temperature at the solder point, the component placement density and the substrate material.
TECHNICAL SPECIFICATIONS
PARAMETER
UNIT
CRCW01005
Rated Dissipation P₇₀ ⁽¹⁾
W
Operating Voltage U_max. AC_RMS/DC
V
Insulation Voltage U_ins (1 min)
V
Insulation Resistance

0.031
15
30
> 10⁹
Operating Temperature Range
°C
-55 to +125
Mass
mg
0.07
Note
(1) _{The power dissipation on the resistor generates a temperature rise against the local ambient, depending on the heat flow support of the}
printed-circuit board (thermal resistance). The rated dissipation applies only if the permitted film temperature of 125 °C is not exceeded.
Revision: 06-Nov-13
1
Document Number: 20056
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000