34THE Datasheet, PDF (1/7 Pages) Vishay Siliconix – Ten Turns Servo or Bushing Mount Hall Effect

www.vishay.com
34 THE
Vishay Spectrol
Ten Turns Servo or Bushing Mount Hall Effect
Sensor in Size 09 (22.2 mm)
QUICK REFERENCE DATA
Sensor type
Multi Turn ROTATIONAL, hall effect
Output type
Wires or rear turrets
Market appliance
Industrial
Dimensions
7/8" (22.2 mm)
FEATURES
• All electrical angles available up to: 3600°
• Accurate linearity down to: ± 0.5 %
• Very long life: 50M cycles for servo, 10M cycles
for bushing
• Non contacting technology: Hall effect; true power on
sensor
• Model dedicated to applications requiring long life
• Material categorization: For definitions of compliance
please see www.vishay.com/doc?99912
ELECTRICAL SPECIFICATIONS
PARAMETER
Electrical angle
Linearity
Supply voltage
Supply current
Output signal
Over voltage protection
Reverse voltage protection
Load resistance recommended
Hysteresis static
STANDARD
SPECIAL
10 turns 3600°
Any other angle upon request
±1%
± 0.5 %
5 V_DC ± 10 %
< 16 mA for single
Other upon request
< 32 mA for redundant
Analog ratiometric 1 % to 99 % of V_supply (other on request)
or PWM 1 kHz, 10 % to 90 % duty cycle or SPI binary on 5 V or binary on 3.3 V
+ 20 V_DC
- 10 V_DC
Min. 1 k for analog output and PWM output
10° on drive shaft
MECHANICAL SPECIFICATIONS
PARAMETER
Mechanical travel
Bearing type
Standard
Resolution
3600° continuous
A sleeve bearing for bushing model/2 ball bearings for servo model
IP 50; other on request
12 bits for analog and PWM, 14 bits for SPI
ORDERING INFORMATION/DESCRIPTION
34 THE
B
1
A
T
MODEL
MOUNTING
TYPE
NUMBER OF
SIGNALS
LINEARITY
OUTPUT
TYPE
B: Bushing 1: Single
A: ± 1 %
S: Servo 2: Redundant B: ± 0.5 %
T: Turrets
Z: Custom
W: Wires
Note
(1) _{SPI output  output type: Wires}
A
2S22
XXXX
BO 1
OUTPUT
SIGNAL
SHAFT
TYPE
SPECIAL
REQUEST
PACKAGING
A: Analog CW
B: Analog CCW
C: PWM CW
D: PWM CCW
E: SPI CW ⁽¹⁾
F: SPI CCW ⁽¹⁾
G: Analog
inverted slope
H: PWM inverted
slope
K: SPI inverted
slope ⁽¹⁾
Z: Other output
2: 3.175 mm
9: Special
P: Plain
S: Slotted
Z: Other type
Box of
1 piece
Shaft length from mounting face standard: 22 mm
e1
LEAD
FINISH
SAP PART NUMBERING GUIDELINES
34 THE
MODEL
S
SERVO
TYPE
2
2 OUTPUT
SIGNALS
B
LINEARITY
B: ± 0.5 %
T
OUTPUT
TYPE
C
OUTPUT
SIGNAL
2P12
SHAFT
TYPE
XXXX
SPECIAL
REQUEST
Revision: 25-Jul-12
1
Document Number: 57114
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000