V150C12C150BL Datasheet, PDF (9/11 Pages) Vicor Corporation – 150V Input Micro Family DC-DC Converter Module

CONTROL FUNCTIONS - PR PIN (CONT.)
+OUT
Module #1
Designated ^SC
Master
–OUT
Plane
+OUT
Module #2
L
trimmed
SC
O
A
down 2 %
D
–OUT
+OUT
Module #3
trimmed SC
down 4 %
–OUT
Ground
Plane
• The +Out and –Out power
buses should be designed
to minimize and balance
parasitic impedance from
each module output to
the load.
• At the discretion of the
power system designer, a
subset of all modules
within an array may be
configured as slaves by
shorting SC to –Out.
• Do not use output ORʼing
diodes with MicroMods.
Figure 11 — N+1 module array output connections.
+Out
SC
R1
R2
U1
R3
2.55 k
R11
36.5 k
PS2701
R4
R5 U2
1.00 k TLV431
R6
C1
1.65 k 470 pF
R7 21.0 k
C3
C2
0.22 µF
R8
4.02 k
Vcc
200 mV
U3
LM10 Gnd
+S
R9
R10
1.24 k
R Load
–S
–Out
See Component Selection section below.
• This module is designed for point of load regulation, where remote sensing
is not required. Active voltage drop compensator, as shown here, may be
used in applications with significant distribution losses.
Please consult with the Micro Family Isolated Remote Sense Application Note
for additional information.
Figure 12 — Voltage drop compensation.
PIN STYLES*
Designator
(None)
L
S
N
F
G
Description
Short Tin/Lead
Long Tin/Lead
Short ModuMate
Long ModuMate
Short RoHS
Long RoHS
Notes
Requires in-board, mounting
On-board mounting for 0.065" boards
SurfMate or in-board socket mounting
On-board socket mounting
Select for RoHS compliant in-board solder, socket, or SurfMate mounting
Select for RoHS compliant on-board solder or socket mounting
* Pin style designator follows the “B” after the output power and precedes the baseplate designator.
Ex. V150C12T150BN2 — Long ModuMate Pins
Vicor Corp. Tel: [phone] Fax: [phone]
150V Micro Family
Set your site on VICOR at vicorpower.com
Rev. 2.0
Page 9 of 11