IB050E096T48N1-CB Datasheet, PDF (5/5 Pages) Vicor Corporation – VI BRICK® IBC Customer Evaluation Board

Recommended Hardware:
QTY Description
Manufacturer P/N Vicor P/N
4
ring lug
Panduit LCAS6-10-L
4
#10-32 screw
4
#10 flat washer
4
#10 lock washer Kit # 37324
4
#10 hex nut
4
self-adhesive rubber feet
Rubber feet can be placed on bottom side of PCB at pad locations 1 through 4.
All hardware is stainless steel except the ring lug.
Kit # 37324 is included with the Customer Evaluation Board.
Thermals
For most lab environments a fan blowing across the evaluation board with at least 200
LFM is recommended. For additional thermal information regarding the IBC refer to the
data sheet or contact Vicor Applications Engineering for assistance [phone].
Caution
The IBC and Customer Evaluation Board can comfortably operate at surface
temperatures which may pose a thermal hazard to the operator. Be careful not to touch
any exposed surface. IBCs may operate at potentially dangerous voltages and pose an
energy hazard. The Customer Evaluation Board is not intended for use in
end item equipment.
Ordering Information
The Customer Evaluation Board is specified by replacing the “–00” suffix with “–CB” to
the appropriate IBC model number.
See: http://www.vicorpower.com/dc-dc-converters-board-mount/vi-brick-intermediate-
bus-conver for model number listings.
The Power Behind Performance
6/2013
vicorpower.com
Applications Engineering: 800 735.6200
Rev 1.4
Page 5