IB054E096T48N1-00 Datasheet, PDF (4/13 Pages) Vicor Corporation – 5:1 Intermediate Bus Converter Module: Up to 500 W Output

IB054E096T48N1-00
SPECIFICATIONS (CONT.)
Control & Interface Specifications
Attribute
Symbol
Conditions / Notes
Min
Typ
Enable (negative logic)*
Module enable threshold
Module enable current
Module disable threshold
Module disable current
Disable hysteresis
Enable pin open circuit voltage
EN to –IN resistance
Enable (positive logic)*
Module enable threshold
Module disable threshold
EN source current (operating)
EN voltage (operating)
*See part numbering on page 11
Referenced to –IN
V_EN = 0.8 V
0.8
130
V_EN = 2.4 V
500
2.5
Open circuit, 10 V applied between EN and -IN
35
Referenced to –IN
2.0
2.5
V_EN = 5 V
4.7
5
IPC-9592A, Based on Class II Category 2 the following detail is applicable. – Pre-conditioning required
Environmental Qualification
Test Description
5.2.3 HALT (Highly Accelerated Life testing)
Test Detail
Low Temp
High Temp
Rapid Thermal Cycling
6 DOF Random Vibration Test
Input Voltage Test
Output Load Test
Combined Stresses Test
5.2.4 THB (Temp. Humidity Bias)
(72 hr presoak required) 1000 hrs – Continuous Bias
5.2.5 HTOB (High Temp. Operating Bias)
5.2.6 TC (Temp. Cycling)
Power cycle - On 42 minutes
Off 1 minute, On 1 minute, Off 1 minute, On 1 minute, Off 1 minute,
On 1 minute, Off 1 minute, On 1 minute, Off 10 minutes. Alternating
between maximum and minimum operating Voltage every hour.
700 cycles , 30 minute dwell at each extreme – 20C minimum ramp rate.
5.2.7 Power Cycling
Reference IPC-9592A
5.2.8 – 5.2.13 Shock and Vibration
Random Vibration – Operating IEC 60068-2-64 (normal operation vibration)
Random Vibration Non-operating (transportation) IEC 60068-2-64
Shock Operating - normal operation shock IEC 60068-2-27
Free fall - IEC 60068-2-32
Drop Test 1 full shipping container (box)
5.2.14 Other Environmental Tests
5.2.14.1 Corrosion Resistance – Not required
5.2.14.2 Dust Resistance – Unpotted class II GR-1274-CORE
5.2.14.3 SMT Attachment Reliability IPC-9701 - J-STD-002
5.2.14.4 Through Hole solderability – J-STD-002
ESD Classification Testing
Total Quantity
Sample size assumes CDM testing
Max
Unit
Vdc
200
µA
2.4
Vdc
10
µA
mV
3.0
Vdc
kΩ
3.0
Vdc
1.45
Vdc
2
mA
5.3
Vdc
Quantity Tested
3
3
3
3
3
3
3
30
30
30
3
3
3
3
3
12
N/A
3
3
5
12
161
IBC MODULE
Page 4 of 13
Rev 1.1
10/2012
vicorpower.com
800 735.6200