V048F080T030-CB Datasheet, PDF (3/9 Pages) Vicor Corporation – PRM® and VTM® Customer Evaluation Boards

6 Test point for Secondary Control (SC)
7 Output voltage points are designed to accommodate #10 hardware and Panduit ring lugs.
8 Output connector (J01) for mating with VTM-CB providing Vout and VC. As shown on the
schematic (Figure 2) there are four pins dedicated to the + Out, four for the -Out, and two for the
VC. Each contact is rated for 3 A. The excess capacity afforded by these pins can facilitate
testing multiple VTM-CBs from a single PRM-CB using an appropriate wiring harness and mating
connector. This may also be achieved using the large pads of Item 7.
9 Output scope jack (J02). Headers H01 and J01 are 0.100" spacing, 10 position female,
manufactured by Sullins Electronics and available from Digi-Key as part # S5519-ND.
Figure 2
PRM-CB schematic diagram
Below is the schematic for this PCB. Double clicking the image will launch Adobe Acrobat to
allow you a better view.
Recommended Hardware
QTY Description
4
ring lug
Manufacturer P/N
Panduit LCAS6-10-L
Kit # 26647 contains:
4 #10-32 screw
4 #10 flat washer
4 #10 lock washer
4 #10 hex nut
All hardware is stainless steel except the ring lug.
Kit # 26647 is included with the Customer Evaluation Board.
UG:003
vicorpower.com
Applications Engineering: 800 927.9474
Page 3