|
V110B24T200BG Datasheet, PDF (11/13 Pages) Vicor Corporation – DC input range 66 – 154 V (continuous) | |||
|
◁ |
PARALLEL BUS OUTPUT
110 V Input
Module 1
+OUT
+S
SC
âS
âOUT
Module 2
+OUT
+S
SC
âS
âOUT
+OUT
+S
Module N+1 SC
âS
âOUT
+S
Load
âS
Figure 11 â N+1 module array output connections.
⢠The +Out and âOut power buses should be designed to
minimize and balance parasitic impedance from each
module output to the load.
⢠The +Sense pins must be tied together to form a
+Sense bus. This must be Kelvin connected to +Out
at a single point. The âSense pins should be tied
together to form a âSense bus. This must be Kelvin
connected to âOut at a single point.
⢠At the discretion of the power system designer,
a subset of all modules within an array may be
configured as slaves by connecting SC to âS.
⢠ORâing diodes may be inserted in series with the
+Out pins of each module to provide module
output fault tolerance.
⢠The +Sense and -Sense leads should be routed in close
proximity to each other on the printed circuit board. If
wires are used to connect the converters on a PCB to
an external load, the Sense leads should be twisted
together to reduce noise pickup.
PINâSTYLES*
Designator
(None)
L
S
N
F
G
Description
Short
Long
Short ModuMate
Long ModuMate
Short RoHS
Long RoHS
Finish
Tin/Lead
Tin/Lead
Gold
Gold
Gold
Gold
Notes
Requires in-board, mounting
On-board mounting for 0.065" boards
SurfMate or in-board socket mounting
On-board socket mounting
Select for RoHS compliant in-board solder, socket, or SurfMate mounting
Select for RoHS compliant on-board solder or socket mounting
* Pin style designator follows the âBâ after the output power and precedes the baseplate designator.
Ex. V110B12T200BN2 â Long ModuMate Pins
110 V Mini Family
Page 11 of 13
Rev 2.7
4/2013
vicorpower.com
800 735.6200
|
▷ |