|
QPI-8L Datasheet, PDF (1/8 Pages) Vicor Corporation – AdvencedTCA Hot-Swap Sip With Active EMI Filter | |||
|
PRELIMINARY
®
QPI-8L
QuietPowerâ¢
AdvancedTCATM Hot-Swap SiP With Active EMI Filter
Description
The QPI-8 is the industryâs first System-in-a-Package (SiP)
designed to integrate a total Hot-Swap function with an
active EMI filter. The product aligns with the
AdvancedTCATM PICMG® 3.0â requirements for hot
insertion and board level conducted noise limitations. The
EMI filter provides active conducted common-mode (CM)
and differential-mode (DM) noise attenuation from
150 kHz to 30 MHz. The QPI-8 is designed for use on a 48
or 60 Volt DC bus (36 â 76 Vdc). The in-rush current limit
and circuit breaker are designed to satisfy the 200 W per
board PICMG® 3.0 limit up to 70°C PCB temperature
around the QPI-8.
The undervoltage and overvoltage thresholds can be
trimmed separately via the UVEN and OV inputs using
external series resistors. The Powergood active-high
output provides opto-coupler drive for a converterâs
active-low enable (see Figure 9a) or active-high by
connecting the diode in series with the Powergood
output (see Figure 9b).
The QPI-8 is available in a 1.0" x 1.0" x 0.2" SiP (System-in-
a-Package) with LGA mounting. QPI-EVAL1 kits are
available with a mounted QPI-8 and screw terminals for
easy insertion and testing. For more information on
Evaluation Boards visit us online at picorpower.com.
Features
⢠>40 dB CM attenuation at 250 kHz
⢠>70 dB DM attenuation at 250 kHz
⢠80 Vdc (max input)
⢠100 Vdc surge 100 ms
⢠1,500 Vdc Hi-pot hold off to Shield Plane
⢠-48 V and -60 V Telecom/ATCA BUS capability
⢠Provides safe powered backplane board insertion
⢠6 A Breaker with delay plus 12 A limiter
⢠1.0" x 1.0" x 0.2" SiP (System-in-a-Package)
⢠QPI-8L Land Grid Array (LGA)
⢠-40° to +100°C PCB temperature (see Figure 5)
⢠Hot-Swap and filter combination saves space
⢠Efficiency >99%
⢠Connects between OR'ing diodes and power
converter input hold-up capacitors
⢠Patents pending
Application
⢠ATCA PICMG® 3.0 boards
Block Diagram
Typical Attenuation
OV
UVEN
BUS+
BUS-
SW
QPI-8
PWRGD
PowerGood
BUS+
QPI+
QPI+
Hot Swap Function
EMI Filter
SW
QPI-
QPI-
SHIELD
Figure 1 - Block diagram, EMI filter and Hot-Swap
Picor Corporation ⢠www.picorpower.com
Figure 2 - QPI-8 network analyzer attenuation curves
QPI-8L Data Sheet Rev. 1.0 Page 1 of 8
|
▷ |