|
QPI-3L Datasheet, PDF (1/8 Pages) Vicor Corporation – 7 Amp Active EMI Filter for 24V DC Bus | |||
|
®
QPI-3L
QuietPowerâ¢
7 Amp Active EMI Filter for 24 V DC Bus
Description
The QPI-3 active EMI filter attenuates conducted
common-mode (CM) and differential-mode (DM) noise
over the CISPR22 frequency range of 150 kHz to 30
MHz. The product is designed for use on a 24 Vdc bus
(10-40 Vdc). The QPI-3âs 7 A rating supports multiple
DC-DC converter loads up to a PCB temperature of
60°C. At a 100°C PCB temperature the QPI-3 supports
6 A loads. Designed for the telecom and ITE bus range,
the QPI-3 supports the PICMG® 3.0 specification for
filtering system boards to the EN55022 Class B limits.
In comparison to passive solutions, the use of active
filtering reduces the volume of the common-mode
choke, providing a low profile, surface mount device.
Smaller size saves valuable board real estate and the
reduced height enhances airflow in blade applications.
The QPI-3 is available in a 1.0" x 1.0" x 0.2" SiP (System
in Package) with LGA mounting. QPI-3-EVAL1 kits are
available for testing the QPI-3. The evaluation board
has a mounted QPI-3 with screw terminals for quick
in-circuit testing.
Check picorpower.com for the QPI-3-EVAL1 evaluation
board and the QPI-AN1 Application Note.
Features
⢠>60 dB CM attenuation at 250 kHz
⢠>80 dB DM attenuation at 250 kHz
⢠40 Vdc (max input)
⢠7 Amp rating
⢠100 Vdc surge 100 ms
⢠707 Vdc Hi-pot hold off to Shield Plane
⢠1.0â x 1.0â x 0.2â SiP (System-in-Package)
⢠SMT Land Grid Array (LGA)
⢠-40° to +100°C PCB temperature (See Fig. 5)
⢠Active filtering reduces volume and height
⢠Efficiency >99% at full load
⢠Connect in series for higher attenuation
⢠TÃV approved
Applications
⢠Industrial bus supplies
⢠Telecom base stations
⢠COTS systems
Typical Application
10 â¦, 1/4 W
Figure 1 - QPI basic input bus filter circuit. Read important
note on page 3 for Layout and Circuit Considerations.
Picor Corporation ⢠www.picorpower.com
QPI Performance
QPI 3 Attenuation
90
80
70
60
50
40
30
20
10
0
0.01
QPI-3 CM QPI-3 DM
0.1
1
10
Frequency [MHz]
Figure 2 - Attenuation curves showing common-mode and
differential-mode attenuation.
QPI-3L Data Sheet Rev. 2.0 Page 1 of 8
|
▷ |