QPI-10 Datasheet, PDF (1/8 Pages) Vicor Corporation – AdvancedTCATM Hot-Swap SiP with VI Chip EMI Filter

®
QPI-10
QUIETPOWER^®
AdvancedTCA^TM Hot-Swap SiP with V•I Chip EMI Filter
Description
The QPI-10 integrates a total hot-swap function with
an EMI filter for V•I Chip applications. The product
aligns with the AdvancedTCA^TM PICMG3.0‚
require-ments for hot insertion and board level
conducted noise limitations. The EMI filter provides
conducted common-mode (CM) and differential-mode
(DM) noise attenuation from 150 kHz to 30 MHz.
The QPI-10 is designed for use on a 48 or 60 Vdc bus
(36 – 76 Vdc). The inrush current limit and circuit
breaker are designed to satisfy the 200 W per board
PICMG3.0‚ limit up to 70°C PCB temperature around
the QPI-10.
The under and overvoltage thresholds can be trimmed
separately via the UVEN and OV inputs using external
series resistors. The QPI-10 provides two Power Good
signals, with one referenced to the input ground and
the other to the output ground, which can be used to
enable other circuits along with the V•I Chip converter.
Features
• > 40 dB CM attenuation at 1 MHz
• > 60 dB DM attenuation at 1 MHz
• 80 Vdc (max input)
• 100 Vdc surge 100 msec
• 1500 V hipot hold off to shield
• 6 A breaker with delay plus 12 A limiter
• 25 mm x 25 mm x 4.5 mm SiP (System-in-Package)
• Low profile LGA package
• - 40° to +100°C PCB temperature (See Fig. 5)
• Hot-swap & filter combined saves PCB space
• Efficiency ~99%
• Connects between OR’ing diodes & power
conversion input hold-up capacitance
• Patents pending
• TÜV approval
Applications
• Telecom & ATCA PICMG^® 3.0 boards using
Vicor’s V•I Chip technology
Figure 1 – Block Diagram
Picor Corporation • www.picorpower.com
Figure 2 – Typical Attenuation
QPI-10 Data Sheet Rev. 1.4 Page 1 of 8