L1119_10 Datasheet, PDF (4/5 Pages) Unisonic Technologies – 1.5A LOW DROPOUT REGULATORS

L1119
Preliminary
CMOS IC
„ ABSOLUTE MAXIMUM RATINGS
PARAMETER
SYMBOL
RATINGS
UNIT
Input Supply Voltage
V_IN
-0.3 ~ +7.5
V
Output Voltage
V_OUT
-0.3 ~ +7.5
V
Output Current
I_OUT
Short Circuit Protected
Power Dissipation
P_D
Internally Limited
°C
Operating Junction Temperature
T_J
-40 ~ +125
°C
Storage Temperature
T_STG
-65 ~ +150
°C
Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
„ RECOMMENDED OPERATING RATINGS
PARAMETER
SYMBOL
RATINGS
UNIT
Input Supply Voltage
V_IN
2.5 ~ 7.0
V
Maximum Operating Current (DC)
I_OPR(MAX)
1.5
A
Operating Junction Temperature
T_J
-40 ~ +125
°C
Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
„ ELECTRICAL CHARACTERISTICS
(T_J=25°C, V_IN =V_OUT+1V, I_L=10mA, C_OUT=33μF, unless otherwise specified.)
PARAMETER
SYMBOL
TEST CONDITIONS
MIN TYP MAX UNIT
Dropout Voltage (Note)
V_D
I_L = 150 mA
I_L = 1.5 A
38 45
mV
870
Peak Output Current
I_PEAK
2.0 2.5
A
Ground Pin Current
I_GND
I_L = 150 mA
I_L = 1.5 A
4
9
mA
5 14
Output Voltage Tolerance
V_OUT
10 mA ≤ I_L ≤ 1.5A
V_OUT +1 ≤ V_IN≤ 7.0V
-1.5 0 +1.5 %
Line Regulation
ΔV_OUT V_OUT+1V<V_IN<7.0V
0.1
%
Load Regulation
SHORT CIRCUIT PROTECTION
ΔV_OUT 10 mA < I_L < 1.5 A
1.5
%
Short Circuit Current
I_SC
AC PARAMETERS
4.5
A
Output Noise Density
ρ_N(l/f) f = 120Hz
0.8
μV
Output Noise Voltage
eN ^{BW = 10Hz – 100kHz}
BW = 300Hz – 300kHz
150
μV(rms)
100
Ripple Rejection
OVER TEMPERATURE PROTECTION
V_IN = V_OUT + 1.5V
RR ^{COUT =100uF, VOUT = 3.3V}
V_IN = V_OUT + 0.3V
C_OUT =100uF, V_OUT = 3.3V
60
dB
40
Shutdown Threshold
T_SHDN
165
°C
Thermal Shutdown Hysteresis
T_HYS
10
°C
Note: Dropout voltage is defined as the minimum input to output differential voltage at which the output drops 2%
below the nominal value. Dropout voltage specification applies only to output voltages of 2.5V and above. For
output voltages below 2.5V, the drop-out voltage is nothing but the input to output differential, since the
minimum input voltage is 2.5V.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
4 of 5
QW-R502-051,Ca