L1806G-SH2-R Datasheet, PDF (2/7 Pages) Unisonic Technologies – With internal Soft-Start

L1806
 MARKING
HSOP-8
DFN-10(3×3)
CMOS IC
 PIN CONFIGURATION
PG ¹
EN 2
V_IN 3
V_CNTL ⁴
GND
8 GND
7 ^FB
6 _VOUT
5 _NC
HSOP-8
NC 1
V_OUT 2
NC 3
FB ₄
PG 5
GND
11
10 V_CNTL
9 NC
8 V_IN
7 NC
6 EN
Top View
DFN-10(3×3)
 PIN DESCRIPTION
PIN NO.
HSOP-8
DFN-10(3×3)
1
5
2
6
3
8
4
10
5
1, 3, 7,9
6
2
7
4
8
11
PIN NAME
DESCRIPTION
PG
EN
V_IN
V_CNTL
NC
V_OUT
FB
GND
Power Good.Output open drain to indicate the status of V_OUT via
monitoring the FB pin. This pin is pulled low when the voltage is
outside the limits, during thermal shutdown and if either V_CNTL or V_IN
go below their thresholds.
Enable Pin. Driving this pin low will disable the part. When left
floating an internal current source will pull this pin high and enable
it.
Power Input Pin for current supply. Connect a decoupling capacitor
(≥10µF) as close as possible to the pin for noise filtering
BIAS supply for the controller, recommended 5V. Connect a
decoupling capacitor (≥1µF) as close as possible to the pin for
noise filtering.
No Connection
Power output pin
Feedback to set the output voltage via an external resistor divider
between V_OUT and GND
Ground
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
2 of 7
QW-R102-063.b