M1008_15 Datasheet, PDF (11/11 Pages) Unisonic Technologies – 16-BIT CCD/CIS ANALOG SIGNAL PROCESSOR

M1008
Preliminary
CMOS IC
„ APPLICATION CONSIDERATIONS
The digital outputs load should be minimized, either by using short traces to the digital ASIC, or by using
external digital buffers. In order to minimize the number of code conversion in the main output of the impact of
transients, which should happen in the coincidences CDSCLK2 falling on or before ADCCLK rising edge. All 0.1μF
decoupling capacitor should be located as close as possible to the M1008 pins. When operating in a single channel
mode, the unused analog inputs should be grounded.
For the 3-channel SHA mode, all of the above considerations also apply for this configuration, except that the
analog input signals are directly connected to the M1008 without the use of coupling capacitors. The OFFSET pin
should be grounded if the inputs to the M1008 are to be referenced to ground, or a DC offset voltage should be
applied to the OFFSET pin in the case where a coarse offset needs to be removed from the inputs. The analog input
signals must already be dc-biased between 0V and 2V, if OFFSET is connected to ground.
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
11 of 11
QW-R502-434.a