UM3304_15 Datasheet, PDF (1/15 Pages) Union Semiconductor, Inc. – 4-Bit Bidirectional Voltage-Level Translator with Auto Direction Sensing and ESD Protection

UM3304/UM3304Q/UM3304QT
4-Bit Bidirectional Voltage-Level Translator with Auto Direction
Sensing and ±4kV ESD Protection
UM3304 CSP12 1.9×1.4
UM3304Q QFN14 3.5×3.5
UM3304QT QFN16 2.6×1.8
General Description
UM3304/UM3304Q/UM3304QT is quad channel level translator with auto direction sensing and
±4kV ESD protection. This 4-channel non-inverting translator uses two separate configurable
power-supply rails. The A port is designed to track V_CCA. V_CCA accepts any supply voltage from
1.2V to 3.6V. The B port is designed to track V_CCB. V_CCB accepts any supply voltage from 1.65V
to 5.5V. This allows for universal low-voltage bidirectional translation between any of the 1.2V,
1.5V, 1.8V, 2.5V, 3.3V, and 5V voltage nodes. Both I/O ports are auto-sensing; thus, no direction
pin is required, making it ideal for data transfer between low-voltage ASICs /PLDs and higher
voltage systems.
The UM3304/UM3304Q/UM3304QT operates at a guaranteed data rate of 20Mbps over the entire
specified operating voltage range. Within specific voltage domains, higher data rates are up to
100Mbps.
When the output-enable (OE) input is low, all outputs are placed in the high-impedance state. The
UM3304/UM3304Q/UM3304QT is designed so that the OE input circuit is designed to track
V_CCA.
To ensure the high-impedance state during power up or power down, OE should be tied to GND
through a pull down resistor; the minimum value of the resistor is determined by the
current-sourcing capability of the driver.
The UM3304 is a quad level translator available in 1.90mm×1.40mm CSP12 bump package while
the UM3304Q is packaged in a 3.50mm×3.50mm QFN14 package and the UM3304QT is
packaged in a 2.60mm ×1.80mm QFN16 package.
Applications
Features
 Low-Voltage ASIC Level Translation
 Cell-Phone Cradles
 Portable POS Systems
 Portable Communication Devices
 Low-Cost Serial Interfaces
 Cell-Phones
 GPS
 Telecommunications Equipment
 1.2V to 3.6V on A Port and 1.65V to 5.5V
on B Port (V_CCA ≤V_CCB)
 V_CC Isolation Feature – If Either V_CC
Input is at GND, All Outputs are in the
High-Impedance State
 OE Input Circuit Referenced to V_CCA
 Low Power Consumption
 Latch-Up Performance Exceeds 100mA
 ±4kV ESD Protection on B Ports
________________________________________________________________________
http://www.union-ic.com Rev.15 Aug.2015
1/15