P6SMB68CA Datasheet, PDF (1/3 Pages) Central Semiconductor Corp – BI-DIRECTIONAL GLASS PASSIVATED JUNCTION TRANSIENT VOLTAGE SUPPRESSOR 600 WATTS, 6.8 THRU 200 VOLTS

Transient Voltage Suppressors
Product specification
P6SMB Series
FEATURES
For surface mounted applications in order to optimize board space.
Low profile package.
Built-in strain relief.
Glass passivated junction.
Low inductance.
Excellent clamping capability.
Repetition Rate (duty cycle): 0.01%.
Fast response time: typically less than 1.0ps from 0 volt to VBR for Unidirectional types.
Typical IR less than 1μA above 10V.
High Temperature soldering: 260°C/10 seconds at terminals.
P
MECHANICAL DATA
M _{Case: JEDEC DO--221041AMA.oMldoelddePdlapsltaics.tic over glass passivated junction.}
Terminals: :SAoxldiaelrlepaladtse,ds, oslodledrearbalbelepeprerMMILI-LS-STDTD-7-5705,0M, Metehtohdod2022062.6.
Polarity: Color abnadnddedneontoetsesctchaothdoedeexceexpceBptipBoidlair.ectional.
MStoaunndtainrdg Paocskitaiognin: gA:n1y.2mm tape (EIA STD RS-481).
Weight: 0.003 ounce, 0.093 grams.
DEVICES FOR BIPOLAR APPLICATION
For Bidirectional use CA suffix for type P6SMB6.8CA through type P6SMB550CA;
Electrical characteristics apply in both directions.
SMB/DO-214AA
MAXIMUM RATINGS AND CHARACTERISTICS
Ratings at 25ć ambient temperature unless otherwise specified.
RATING
SYMBOL
VALUE
Peak Pulse Power Dissipation on 10/1000ȝs waveform. (Note 1, Note 2, Fig. 1)
Peak Pulse Current on 10/1000ȝs waveform. (Note 1,Fig. 3)
Steady State Power Dissipation at T_L =75ćˈLead length .375”ˈ(9.5mm).
(Note 2, Fig. 5)
Peak Forward Surge Currentˈ8.3ms Single Half Sine-Wave Superimposed
on Rated Load. (JEDEC Method) (Note 3, Fig. 6)
Operating junction and Storage Temperature Range.
P_PPM
I_PPM
P_M(AV)
I_FSM
T_J , T_STG
Minimum 600
See Table
5.0
100
-65 to +150
Notes: 1. Non-repetitive current pulse, per Fig. 3 and derated above TA = 25ć per Fig. 2.
N _{2. Mounted on 5.0mm x 5.0mm (0.03mm thick) Copper Pads to each terminal.}
3. 8.3²ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minute maximum.
All specificatio^.ns are subject to change without notice.
UNIT
Watts
Amps
Watts
Amps
ć
http://www.twtysemi.com
[e-mail]
4008-318-123
1 of 3