TS5201_07 Datasheet, PDF (1/7 Pages) Taiwan Semiconductor Company, Ltd – 200mA Low Noise LDO Voltage Regulator with Enable

TS5201
200mA Low Noise LDO
Voltage Regulator with Enable
SOP-8
Pin Definition:
1. Output
2. ADJ / N/C
3. Ground
4. N/C
8. Input
7. N/C
6. N/C
5. Enable
General Description
TS5201 is an efficient linear voltage regulator with ultra low noise output, very low dropout voltage (typically 17mV at
light loads and 165mV at 200mA), and very low power consumption (600uA at 100mA), providing high output current
even when the application requires very low dropout voltage. The Chip Enable (EN) includes a CMOS or TTL
compatible input allows the output to be turned off to prolong battery life. When shutdown, power consumption drops
nearly to zero. TS5201 is included a precision voltage reference, error correction circuit, a current limited output
driver, over temperature shutdown, revered battery protection and a reference bypass pin to improve its already
excellent low-noise performance.
Features
● Ultra Low Noise Output
● Output Current up to 200mA
● Low Dropout Voltage
● Low Power Consumption
● “Zero” Off-mode Current
● Logic Controlled Electronic Enable
● Internal Current Limit
● Thermal Shutdown Protection
Application
● Cellular Telephones
● Palmtops, Notebook Computers
● Battery Powered Equipment
● Consumer and Personal Electronics
● SMPS Post Regulator and DC to DC Modules
● High-efficiency Linear Power Supplies
● Portable Application
Ordering Information
Part No.
Package
Packing
TS5201CSxx RF SOP-8
2.5Kpcs / 13” Reel
Note: Where xx denotes voltage option, available are
50=5.0V
33=3.3V
30=3.0V
25=2.5V
Leave blank for adjustable version. Contact factory
for additional voltage options.
Typical Application Circuit
V_OUT
TS5201CSxx
V_IN
C_OUT
2.2uF
EN
on
off
V_OUT
TS5201CS
V_IN
C_OUT
R1
2.2uF
R2
EN
on
off
Adjustable Version: V_OUT = 1.24 (R1+R2)/R2
(Adjustable output range up to 8V)
EN (pin3) may be connected directly to V_IN (pin 1)
Low noise operation: C_BYP =470pF, C_OUT >2.2uF
Basic operation: C_BYP =not used, C_OUT >2uF
1/7
Version: A07