TS4268_08 Datasheet, PDF (1/7 Pages) Taiwan Semiconductor Company, Ltd – 180mA Fixed-Voltage Ultra Low LDO

TS4268
180mA Fixed-Voltage Ultra Low LDO
SOP-8
Pin Definition:
1. IN 8. OUT
2. N/C 7. WI
3. RO 6. RADJ
4. GND 5. RD
General Description
TS4268 is a 5V low-drop fixed-voltage regulator. The maximum input voltage is 45 V. It can deliver an output current of
at least 180mA. TS4268 is short-circuit proof and features temperature protection that disables the circuit in the event
of impermissibly high temperatures. The watchdog function is disabled as a function of the load, so that a controller is
not interrupted during sleep mode by a watchdog reset.
Application Description
TS4268 regulates an input voltage in the range 5.5V ~ 45V. In the event of an output voltage Vout < V_RT, a reset signal
is generated. The wiring of the reset switching threshold input enables the value of V_RT to be reduced. The reset delay
time can be adjusted using an external capacitor. The integrated watchdog monitors the connected active controller. If
there is no positive-going edge at the watchdog input, the reset output is set to low. The reset delay capacitor provides
a wide adjustment range for the pulse repetition time. The watchdog function is only activated if the load exceeds 8mA.
This ensures that a microcontroller is not activated during power-down and the current drain is not increased. The IC is
protected against overload and over temperature.
Features
● Output voltage tolerance <±2%
● Very low current consumption
● Low-drop voltage
● Watchdog
● Settable reset threshold
● Over temperature protection
● Reverse polarity protection
● Short-circuit proof
● Suitable for use in automotive electronics
● Wide temperature range
Ordering Information
Part No.
TS4268CS50 RL
Package
Packing
SOP-8
2.5Kpcs / 13” Reel
Pin Description
Pin No. Symbol
1
IN
2
N/C
3
RO
4
GND
5
RD
6
RADJ
7
WI
8
OUT
Pin Description
Input Voltage. block to ground directly with ceramic capacitor
Not Connected
Reset Output. the open collector output is connected to the 5V output via an integrated
resistor of 30kΩ
Ground
Reset Delay. connect a capacitor to ground for delay time adjustment.
Reset Switching Threshold. for setting the switching threshold, output to ground with
voltage divider. If this input is connected to ground, the reset is triggered at an output
voltage of 4.5V.
Watchdog Input. positive-edge-triggered input for monitoring a microcontroller.
Output Voltage. block to ground with 22uF capacitor, ESR <3Ω
1/7
Version: B07