TS2596_13 Datasheet, PDF (1/9 Pages) Taiwan Semiconductor Company, Ltd – 3A / 150KHz Buck Dc-Dc Converter

TO-220-5L
TS2596
3A / 150KHz Buck Dc-Dc Converter
TO-263-5L
(D²PAK)
Pin Definition:
1. Input
2. SW Output
3. Ground
4. Feedback
5. Enable
General Description
The TS2596 Series are step-down switching regulators with all required active functions. It is capable of driving
3A load with excellent line and load regulations. These devices are available in fixed output voltages of 3.3V, 5V,
and an adjustable output version.
The TS2596 series operates at a switching frequency of 150kHz thus allowing smaller sized filter components
than what would be needed with lower frequency switching regulators. It substantially not only reduces the area of
board size but also the size of heat sink, and in some cases no heat sink is required. The ±4% tolerance on output
voltage within specified input voltages and output load conditions is guaranteed. Also, the oscillator frequency
accuracy is within ±10%. External shutdown is included. Featuring 100µA (typical) standby current. The output
switch includes cycle-by-cycle current limiting, as well as thermal shutdown for full protection under fault
conditions.
Features
● Output Voltage: 3.3V, 5V & Adjustable version
● Adjustable Output Voltage Range 1.23V~38.5V
● 150KHz fixed switching frequency
● Voltage Mode Non-synchronous PWM control
● Thermal Shutdown and Current Limit Protection
● ON/OFF Shutdown Control Input
● High Efficiency
● Short Circuit Protect (SCP)
● Operating Voltage Can be up to 40V
● Output Load Current 3A
● Low Power Standby Mode
● Built-in switching transistor on chip
Ordering Information
Part No.
Package
Packing
TS2596CZ5xx C0 TO-220-5L
50pcs / Tube
TS2596CM5xx RN TO-263-5L 800pcs / 13” Reel
Note: Where xx denotes voltage option, available are
50= 5.0V
33= 3.3V
Leave blank for adjustable version
Application
● Simple High-efficiency Step down Regulator
● On-Card Switching Regulators
● Positive to Negative Converter
Absolute Maximum Rating
Parameter
Maximum Supply Voltage
Recommend Operating Supply Voltage
SW, EN Pin Input Voltage
Feedback Pin Voltage
Power Dissipation
Output Voltage to Ground
Storage Temperature Range
Operating Temperature Range
ESD Susceptibility (HBM)
Symbol
V_CC
V_OP
V_SW, V_EN
V_FB
P_D
V_OUT
T_ST
T_OP
Limit
+45
+4.5 to +40
-0.3 to +40
-0.3 to +12
Internally Limited
-1
-65 to +150
-40 to +125
2
Unit
V
V
V
V
W
V
o_C
o_C
kV
1/9
Version: E13