TS2496_09 Datasheet, PDF (1/7 Pages) Taiwan Semiconductor Company, Ltd – 2A / 150KHz Buck Switching Regulator

TO-263-5L
(D²PAK)
Pin Definition:
1. Input
2. SW Output
3. Ground
4. Feedback
5. Enable
TS2496
2A / 150KHz Buck Switching Regulator
General Description
TS2496 Series are step-down switching regulators with all required active functions. It is capable of driving 2A load
with excellent line and load regulations. These devices are available in fixed output voltages of 3.3V, 5V and an
adjustable output version.
TS2496 series operates at a switching frequency of 150kHz thus allowing smaller sized filter components than what
would be needed with lower frequency switching regulators. It substantially not only reduces the area of board size
but also the size of heat sink, and in some cases no heat sink is required. The ±4% tolerance on output voltage within
specified input voltages and output load conditions is guaranteed. Also, the oscillator frequency accuracy is within
±10%. External shutdown is included. Featuring 80µA (typical) standby current. The output switch includes cycle-by-
cycle current limiting, as well as thermal shutdown for full protection under fault conditions.
Features
● Output Voltage: 3.3V, 5V & Adjustable version
● Adjustable Output Voltage Range 1.23V~19.5V ±4%
● 150KHz fixed switching frequency
● Voltage Mode Non-synchronous PWM control
● Thermal Shutdown and Current Limit Protection
● ON/OFF Shutdown Control Input
● High Efficiency
● Short Circuit Protect (SCP)
● Operating Voltage Can be up to 24V
● Output Load Current 2A
● Low Power Standby Mode
● P+ Product Enhancement Tested
Ordering Information
Part No.
Package
Packing
TS2496CMxx RN TO-263-5L 800pcs / 13” Reel
Note: Where xx denotes voltage option, available are
50= 5.0V
33= 3.3V
Leave blank for adjustable version
Application
● Simple High-efficiency Step down Regulator
● On-Card Switching Regulators
● Positive to Negative Converter
Absolute Maximum Rating
Parameter
Maximum Supply Voltage
Recommend Operating Supply Voltage
SW, EN Pin Input Voltage
Feedback Pin Voltage
Power Dissipation
Output Voltage to Ground
Storage Temperature Range
Operating Temperature Range
ESD Susceptibility (HBM)
Symbol
V_CC
V_OP
V_SW, V_EN
V_FB
P_D
V_OUT
T_ST
T_OP
Limit
+28
+4.5 to +24
-0.3 to V_CC
-0.3 to V_CC
Internally Limited
-1
-65 to +150
-20 to +125
2
Unit
V
V
V
V
W
V
o_C
o_C
kV
1/7
Version: C07