SMBJ5.0 Datasheet, PDF (1/4 Pages) Littelfuse – Silicon Avalanche Diodes - 600W Surface Mount Transient Voltage Suppressors

SMBJ SERIES
Surface Mount Transient Voltage Suppressor
Voltage Range
5.0 to 170 Volts
600 Watts Peak Power
Features
SMB/DO-214AA
For surface mounted application
Low profile package
Built-in strain relief
Glass passivated junction
Excellent clamping capability
Fast response time: Typically less than 1.0ps from 0 volt to
BV min.
Typical IR less than 1μA above 10V
High temperature soldering guaranteed:
260^OC / 10 seconds at terminals
Plastic material used carries Underwriters Laboratory
Flammability Classification 94V-0
600 watts peak pulse power capability with a 10 x 1000 us
waveform by 0.01% duty cycle
Mechanical Data
Case: Molded plastic
Terminals: Solder plated
Polarity: Indicated by cathode bandexcept bipolar
Standard packaging: 12mm tape (EIA STD RS-481)
Weight: 0.093gram
.082(2.08)
.076(1.93)
.147(3.73)
.137(3.48)
.187(4.75)
.167(4.25)
.012(.31)
.006(.15)
.103(2.61)
.078(1.99)
.056(1.41)
.035(0.90)
.008(.20)
.004(.10)
.208(5.28)
.200(5.08)
.012(.31)
.006(.15)
Dimensions in inches and (millimeters)
Maximum Ratings and Electrical Characteristics
Rating at 25℃ambient temperature unless otherwise specified.
Type Number
Peak Power Dissipation at TA=25^OC, Tp=1ms(Note
1)
Symbol
P_PK
Value
Minimum 600
Units
Watts
Steady State Power Dissipation
Pd
3
Watts
Peak Forward Surge Current, 8.3 ms Single Half
Sine-wave Superimposed on Rated Load
(JEDEC method) (Note 2, 3) - Unidirectional Only
I_FSM
100
Amps
Maximum Instantaneous Forward Voltage at
50.0A for Unidirectional Only (Note 4)
V_F
3.5 / 5.0
Volts
Typical Thermal Resistance (Note 5)
Rθ_JL
10
Rθ_JA
55
Operating and Storage Temperature Range
T_J, T_STG
-65 to + 150
Notes: 1. Non-repetitive Current Pulse Per Fig. 3 and Derated above TA=25^OC Per Fig. 2.
℃/W
O_C
2. Mounted on 0.4 x 0.4" (10 x 10mm) Copper Pads to Each Terminal.
3. 8.3ms Single Half Sine-wave or Equivalent Square Wave, Duty Cycle=4 pulses Per Minute
Maximum.
4. VF=3.5V on SMBJ5.0 thru SMBJ90 Devices and VF=5.0V on SMBJ100 thru SMBJ170 Devices.
5. Measured on P.C.B. with 0.27” x 0.27” (7.0mm x 7.0mm) Copper Pad Areas.
Devices for Bipolar Applications
1. For Bidrectional Use C or CA Suffix for Types SMBJ5.0 through Types SMBJ170.
2. Electrical Characteristics Apply in Both Directions.
- 602 -