HS2A Datasheet, PDF (1/2 Pages) Taiwan Semiconductor Company, Ltd – 2.0 AMPS. High Efficient Surface Mount Rectifiers

HS2A THRU HS2M
Features
2.0 AMPS. High Efficient Surface Mount Rectifiers
Voltage Range
50 to 1000 Volts
Current
2.0 Amperes
SMB/DO-214AA
Glass passivated junction chip.
For surface mounted application
Low forward voltage drop
Low profile package
Built-in stain relief, ideal for automatic
placement
Fast switching for high efficiency
High temperature soldering:
260℃/10 seconds at terminals
Plastic material used carries Underwriters
Laboratory Classification 94V-O
Mechanical Data
Cases: Molded plastic
Terminals: Solder plated
Polarity: Indicated by cathode band
Packing: 12mm tape per E1A STD RS-481
Weight: 0.093 gram
.082(2.08)
.076(1.93)
.147(3.73)
.137(3.48)
.187(4.75)
.167(4.25)
.012(.31)
.006(.15)
.103(2.61)
.078(1.99)
.056(1.41)
.035(0.90)
.008(.20)
.004(.10)
.208(5.28)
.200(5.08)
.012(.31)
.006(.15)
Dimensions in inches and (millimeters)
Maximum Ratings and Electrical Characteristics
Rating at 25℃ambient temperature unless otherwise specified.
Single phase, half wave, 60 Hz, resistive or inductive load.
For capacitive load, derate current by 20%
Type Number
Symbo HS HS HS HS HS HS HS HS Units
l 2A 2B 2D 2F 2G 2J 2K 2M
Maximum Recurrent Peak Reverse Voltage _VRRM 50 400 200 300 400 600 800 1000 V
Maximum RMS Voltage
V_RMS 35 70 140 210 280 420 560 700 V
Maximum DC Blocking Voltage
Maximum Average Forward Rectified
Current See Fig. 2
V_DC 50 100 200 300 400 600 800 1000 V
I_(AV)
2.0
A
Peak Forward Surge Current, 8.3 ms Single
Half Sine-wave Superimposed on Rated
I_FSM
50
A
Load (JEDEC method )
Maximum Instantaneous Forward Voltage
@ 2.0A
V_F
1.0
1.3
1.7
V
Maximum DC Reverse Current
@TA =25℃ at Rated DC Blocking Voltage
IR
@ TA=100℃
5.0
uA
100
uA
Maximum Reverse Recovery Time (Note 1) Trr
50
75
nS
Typical Junction Capacitance (Note 2)
Cj
50
30
pF
Maximum Thermal Resistance (Note 3)
RθJA
80
℃/W
Operating Temperature Range
TJ
-55 to +150
℃
Storage Temperature Range
TSTG
-55 to +150
℃
Notes: 1. Reverse Recovery Test Conditions: IF=0.5A, IR=1.0A, IRR=0.25A
2. Measured at 1 MHz and Applied VR=4.0 Volts
3. Mounted on P.C.B. with 0.4”x0.4” ( 10 x 10 mm ) Copper Pad Areas.
- 302 -