TMPC-650U Datasheet, PDF (1/2 Pages) Tumbler Technologies + TRUMPower – UPS-Ready Medical Grade 650W ATX Power Supply

TMPC-650U
UPS-Ready Medical Grade 650W ATX Power Supply
FEATURES
• 90-264 VAC Input
• Built-in 24V Lead-Acid Battery Charger
• UPS-Ready, Power Management Software Included
• Active PFC meets EN 61000-3-2 Standard
• CB Test Report per IEC/EN 60601-1 3rd Edition
• Medically Approved to UL ES60601-1 & CSA 60601-1:2008
INPUT SPECIFICATIONS
Input Voltage Range ............ 90~264 VAC
Input Frequency ................... 47~63Hz
Input Current ........................ 10A rms max. @ 100 VAC, 60Hz
5A rms max. @ 230 VAC, 50Hz
Inrush Current ...................... 23.6A @ 115 VAC, 53A @ 230
............................................. VAC, at 25°C cold start
Earth Leakage Current ........ 300µA max. @ 264 VAC, 63Hz
OUTPUT SPECIFICATIONS
Output Power Ratings ................ See rating chart
Load Regulation ......................... See rating chart
Line Regulation ........................... ±1% max. @ full load
Ripple & Noise* .......................... See rating chart
Hold-up Time .............................. 17ms min. @ 115/230 VAC
Switching Frequency .................. 70 KHz ±10 KHz
Overvoltage Protection ............... 3.76~4.3V for +3.3V
5.74~7.0V for +5V
13.4~15.6V for +12V
Overcurrent Protection ............... 32A max. for +3.3V
32A max. for +5V
24A max. for +12V
Short-Circuit Protection .............. All outputs protected to output
.................................................... rail shorted to return conditions
Thermal Protection ..................... Shutdown and latch off
Backup Battery (Not Included) ... 24V lead-acid type
Charge Current ........................... Constant voltage and current
.................................................... charge 2.5A max.
* Measured with 20MHz bandwidth at rated line voltage and output load ranges,
with a 47µF tantalum capacitor in parallel with a 0.1µF ceramic capacitor in
parallel across the output.
GENERAL SPECIFICATIONS
Efficiency ............................ 78% min. @ full load
Power Factor ..................... >0.9 typ. @ full load
Operating Temperature ...... 0°C to +70°C
Derating ............................. Derate from 100% @ +50°C linearly
to 50% @ +70°C
Storage Temperature ......... -20°C to +85°C
Relative Humidity ............... 10% to 95% non-condensing
Withstand Voltage .............. 4,000 VAC from input to output
........................................... 1,500 VAC from input to ground
MTBF ................................. 194,206 hours mininum at full load &
25°C ambient, calculated per
Bellcore/Telcordia SR-332
STANDARDS & COMPLIANCES
IEC/EN 60601-1-2 ............. EMC & Immunity Performance
EN 55011 ........................... Class B conducted, Class A radiated
FCC / VCCI ........................ Class B conducted, Class A radiated
EN 61000-3-2 .................... Harmonic distortion, Class D
EN 61000-3-3 .................... Line flicker
EN 61000-4-2 .................... ESD, ±8 KV air and ±6 KV contact
EN 61000-4-3 .................... Radiated immunity, 3 V/m
EN 61000-4-4 .................... Fast transient/burst, ±2 KV
EN 61000-4-5 .................... Surge, ±1 KV diff., ±2 KV com.
EN 61000-4-6 .................... Conducted immunity, 3 Vrms
EN 61000-4-8 .................... Magnetic field immunity, 3 A/m
EN 61000-4-11 ................... Voltage dip immunity, 30% reduction
........................................... for 500ms, 60% reduction for 100ms
........................................... and >95% reduction for 10ms
Safety Standards ............... UL ES60601-1, CSA 60601-1:2008,
IEC/EN 60601-1 3rd edition
Agency Approvals .............. UL, cUL, CB (report)
Other Compliance .............. RoHS
OUTPUT VOLTAGE & CURRENT RATING CHART
Ouptut
Voltage
Minimum
Load
*Maximum
Load
Load
Ripple & Noise
Regulation
VP-P Max.
+3.3V
0.5A
24A
±5%
50mV
+5V
0.3A
24A
±5%
50mV
+12V1
1A
16A
±5%
120mV
+12V2
1A
16A
±5%
120mV
+12V3
1A
16A
±5%
120mV
+12V4
1A
16A
±5%
120mV
-12V
0A
0.5A
±10%
120mV
+5Vsb
0A
3A
±5%
50mV
* The overall output power with battery charger is 650W maximum.
* The total output power for +3.3V & +5V is 150W maximum .
* The total output power for +12V1, +12V2, +12V3 & +12V4 is 600W maximum.
* The total output power for +3.3V, +5V, and +12V is 600W.
Tumbler Technologies + TRUMPower
3350 Scott Blvd., Building 13 • Santa Clara, California 95054, USA • 408-988-6616 • [e-mail] • www.TRUMPower.com