TMP92 Datasheet, PDF (1/2 Pages) Tumbler Technologies + TRUMPower – 90 Watts Medical Grade Power Adapters

TRUMPower
TMP92 Series
90 Watts Medical Grade Power Adapters
FEATURES
• 0.87" Slim Case
• Low Cost
• Class I (2MOPP) & Class II (1MOPP) Models Available
• Low Safety Ground Leakage Current
• Compliant with CEC & Energy Star Level V
• 100% Burn-in Tested
INPUT SPECIFICATIONS
Input Voltage Range ............ 90~264 VAC
Input Frequency ................... 47~63Hz
Input Current ........................ 1.5A rms @ 90 VAC
Inrush Current ..................... 40 A @ 115 VAC or 80 A @ 230 VAC,
at 25°C cold start
Earth Leakage Current ........ 160µA max. @ 264 VAC, 63Hz
............................................. (for Class I models only)
Touch Current ...................... 40µA max. @ 264 VAC, 63Hz
............................................. (for Class I and Class II models)
No Load Power .................... 0.21W typical
OUTPUT SPECIFICATIONS
Output Power Ratings .......... See table
Tolerance ............................. ±5%
Ripple and Noise* ............... 300mV peak to peak max. at full load
Overvoltage Protection ........ 36 Vdc max., Latch off
Overcurrent Protection ........ 6A max., Auto-recovery
Over-Temp. Protection ........ Latch off
Short Circuit Protection ....... Auto-recovery
Temperature Coefficient ..... ±0.04%/°C max.
Turn-On Delay ..................... 3 sec. @ 100 VAC, 60Hz
Transient Response ........... Max. excursion of 4% or better on
all models, recovering to 1% of
final value within 500 µs after a
25% step load change
* Measured with 20MHz bandwidth at rated line voltage and output load ranges,
with a 10µF tantalum capacitor in parallel with a 0.1µF ceramic capacitor in
parallel across the output.
GENERAL SPECIFICATIONS
Power Factor ....................... 0.9 typical @ 115 VAC
Efficiency ............................. 88% minimum at full load
Hold-up Time ....................... 10 ms min. @ 115 VAC, 60Hz
Switching Frequency ........... 75~100KHz
Line Regulation ................... ±1% maximum at full load
Operating Temperature ...... 0°C to +40°C
Derating ............................... Derate from 100% at +40°C linearly
to 50% at +60°C
Storage Temperature .......... -40°C to +85°C
Relative Humidity ................ 5% to 90% non-condensing
Withstand Voltage ............... 4000 VAC from input to output
............................................. 1500 VAC from input to ground
MTBF .................................... 100K hours minimum at full load,
25°C ambient, calculated per
MIL-HDBK-217F
MODELS LIST
Product No.
TMP92-12
TMP92-18
TMP92-19
TMP92-24
TMP92-12-2R
TMP92-18-2R
TMP92-19-2R
TMP92-24-2R
Output
Voltage
Maximum
Current
Class I (IEC 320/C6 Inlet)
12 V
7.5 A
18 V
5A
19 V
4.74 A
24 V
3.75 A
Class II (IEC 320/C8 Inlet)
12 V
7.5 A
18 V
5A
19 V
4.74 A
24 V
3.75 A
Maximum
Power
90 W
90 W
90 W
90 W
90 W
90 W
90 W
90 W
STANDARDS & COMPLIANCES
IEC/EN 60601-1-2 ............. EMC & Immunity Performance
EN 55011, FCC, VCCI ....... Class B, conducted & radiated
EN 61000-3-2 .................... Harmonic distortion, Class A
EN 61000-3-3 .................... Line flicker
EN 61000-4-2 .................... ESD, ±8 KV air and ±6 KV contact
EN 61000-4-3 .................... Radiated immunity, 3 V/m
EN 61000-4-4 .................... Fast transient/burst, ±2 KV
EN 61000-4-5 .................... Surge, ±1 KV diff., ±2 KV com.
EN 61000-4-6 .................... Conducted immunity, 3 Vrms
EN 61000-4-8 .................... Magnetic field immunity, 3 A/m
EN 61000-4-11 .................. Voltage dip immunity,
30% reduction for 500ms,
60% reduction for 100ms,
>95% reduction for 10ms
Safety Standards ............... IEC/EN/UL 60601-1 3rd Edition,
ANSI/AAMI ES 60601-1 1st Edition,
CSA-C22.2 No. 60601-1 2nd Edition
Agency Approvals .............. UL, TUV, CE, CB
Other Compliances .......... RoHS, CEC & Energy Star Level V
Tumbler Technologies + TRUMPower
3350 Scott Blvd., Building 13 • Santa Clara, California 95054, USA • 408-988-6616 • [e-mail] • www.TRUMPower.com