TMP90 Datasheet, PDF (1/2 Pages) Tumbler Technologies + TRUMPower – 90 WATTS MEDICAL POWER ADAPTERS

TRUMPower
90 WATTS MEDICAL POWER ADAPTERS
DESCRIPTION
The TMP90 is a series of AC/DC desktop power
adapters with 60 to 90 watts of continuous output
power. They are enclosed in a 94V-1 rated case with
an IEC 320/C14 or C18 inlet for medical and ITE
applications. All models meet EN55011, EN55022 and
FCC class B emission limits, and are designed for
medical applications.
TMP90 SERIES
( LV D )
RoHS
F E AT U R E S
‧ Low safety ground leakage current
‧ IEC320/C14 (Class I) or C18 (Class II) Inlet
‧ 90 to 264VAC wide input range
‧ Optional output connectors
‧ Overvoltage & overcurrent protections
‧ 0.98 PFC
‧ 100% burn-in
‧ Compliant with CEC and Energy Star efficiency
level IV requirements (except ≤12V output models)
‧ No load power consumption less than 0.5W
‧ Average active efficiency ≥85%
‧ Compliant with RoHS requirements
Safety Standard Approvals：
UL 60601-1
CSA C22.2 No. 601.1
TÜV EN60601-1
INPUT SPECIFICATIONS
Input voltage :
Input frequency :
Input current :
Earth leakage current :
90 to 264VAC
47 to 63Hz
1.20A (rms) for 115VAC
0.60A (rms) for 230VAC
90µA max. @ 115VAC, 60Hz
150µA max. @ 230VAC, 50Hz
OUTPUT SPECIFICATIONS
Output voltage/current：
Total output power：
Ripple and noise：
Over voltage protection：
Over current protection：
Temperature coefficient：
Transient response：
See rating chart
See rating chart
2% peak to peak maximum
Set at 112-140% of its nominal
output voltage
Protected to short circuit
conditions
±0.04%/ºC maximum
Maximum excursion of 4% or
better on all models, recovering
to 1% of final value within 500µs
after a 25% step load change
ENVIRONMENTAL SPECIFICATIONS
O p e r a t i n g t e m p e r a t u r e ： 0 ºC t o + 6 0 ºC
S t o r a g e t e m p e r a t u r e ： - 4 0 ºC t o + 8 5 ºC
Relative humidity：
5% to 95% non-condensing
Derating：
Derate from 100% at +40ºC
linearly to 50% at +60ºC
GENERAL SPECIFICATIONS
Switching frequency： 50 KHz - 110 KHz
Power factor：
0.98 Typical
Efficiency：
85% min. (78% min. for TMP90-05,
TMP90-06, TMP90-09 and TMP90-12)
Hold-up time：
15 msec minimum at 110VAC
Line regulation：
±0.5% maximum at full load
Inrush current：
40 amps @ 115VAC or 60 amps @
230VAC, @ 25ºC cold start
Withstand voltage： 4000VAC from input to output
1500VAC from input to ground
500VAC from output to ground
MTBF：
150,000 hours minimum at full load
at 25ºC ambient, calculated per
MIL-HDBK-217F
EMC Performance (IEC60601-1-2: 2001)
EN55011:
FCC:
VCCI:
EN61000-3-2:
EN61000-3-3:
EN61000-4-2:
Class B conducted, Class B radiated
Class B conducted, Class B radiated
Class B conducted, Class B radiated
Harmonic distortion, Class A and D
Line flicker
ESD, ±8KV air and ±6KV contact
EN61000-4-3:
Radiated immunity, 3V/m
EN61000-4-4:
Fast transient/burst, ±2KV
EN61000-4-5:
Surge, ±1KV diff, ±2KV com.
EN61000-4-6:
Conducted immunity, 3Vrms
EN61000-4-8:
Magnetic field immunity, 3A/m
EN61000-4-11:
Voltage dips, 30% reduction for 500ms,
60% reduction for 100ms and >95%
reduction for 10ms
Tumbler Technologies + TRUMPower
3350 Scott Blvd., Bldg. 13, Santa Clara, California 95054, USA
Phone: [phone] ● Fax: [phone] ● email: [e-mail] ● Website: www.TRUMPower.com