TMP220 Datasheet, PDF (1/2 Pages) Tumbler Technologies + TRUMPower – 200-220 Watts Medical & ITE Power Adapters

TRUMPower
TMP220 Series
200-220 Watts Medical & ITE Power Adapters
FEATURES
• Class I (C14 Inlet) & Calss II (C8 Inlet)
• 0.95 Active Power Factor
• 87% Minimum Efficiency
• Medical & ITE Dual Approvals
• Short-Circuit, OVP, OLP, and OTP Protections
• Standby Power Consumption < 0.5W
• CEC & Energy Star Level V Compliance
• 100% Burn-In at Full Rated Load
INPUT SPECIFICATIONS
Input Voltage Range ............... 90~264 VAC
Input Frequency ...................... 47~63Hz
Input Current ........................... 3.0A rms @ 115 VAC
................................................ 1.5A rms @ 230 VAC
Touch Current ......................... 100µA max. @ 264 VAC, 60Hz
Earth Leakage Current ........... 300µA max. @ 264 VAC, 60Hz
OUTPUT SPECIFICATIONS
Output Power Ratings ............ See table
Tolerance ................................ ±5%
Ripple and Noise* .................. 280mV peak to peak max.
Overvoltage Protection ........... Set at 110-130% of its nominal
output voltage
Overcurrent Protection ........... Protected 110-120% of full load
................................................ conditions
Transient Response .............. +4% max. excursion, Recovering
to 1% of final value within 500µs
after a 25% load change
* Measured with 20MHz bandwidth at rated line voltage and output load ranges, with
a 47µF electrolytic capacitor in parallel with a 0.1µF ceramic capacitor across the
output.
GENERAL SPECIFICATIONS
Power Factor .......................... 0.95 typical
Efficiency ................................ 87% min. at 100 VAC or 240 VAC
Hold-up Time .......................... 12ms min. at 100 VAC
Turn-on Delay Time ................ 3 sec. max. at 100 VAC
Line Regulation ...................... ±0.5% max. at full load
Operating Temperature ......... 0°C to +40°C
Storage Temperature ............. -20°C to +80°C
Relative Humidity ................... 10% to 90% non-condensing
Withstand Voltage .................. 4000 VAC from input to output,
................................................ 1500 VAC from input to ground
MTBF ....................................... 125K hours minimum at full load,
25°C ambient, calculated per
MIL-HDBK-217F
STANDARDS & COMPLIANCES
IEC/EN 61000-1-2 ................. EMC & Immunity Performance
EN 55011, EN 55022 ............ Class B, conducted & radiated
FCC, VCCI ............................. Class B, conducted & radiated
EN 61000-3-2 ........................ Harmonic distortion, Class A & D
EN 61000-3-3 ........................ Line flicker
EN 61000-4-2 ........................ ESD, ±8 KV air and ±6 KV contact
EN 61000-4-3 ........................ Radiated immunity, 3V/m
EN 61000-4-4 ........................ Fast transient/burst, ±2 KV
EN 61000-4-5 ........................ Surge, ±1 KV diff., ±2 KV com.
EN 61000-4-6 ........................ Conducted immunity, 3 Vrms
EN 61000-4-8 ........................ Magnetic field immunity, 3A/m
EN 61000-4-11 ...................... Voltage dips,
30% reduction for 500ms,
60% reduction for 100ms,
>95% reduction for 10ms
Safety Standards ................... IEC/EN/UL 60601-1 3rd Ed.
............................................... ANSI/AAMI ES 60601-1:2005,
............................................... CSA C22.2 No. 60601-1:08,
............................................... IEC/EN 60950-1 2nd Ed.
Agency Approvals .................. UL, cUL, TUV, CE, CB
Other Compliances .............. RoHS, CEC & Energy Star Level V
MODELS LIST
Product No.
TMP220-19
TMP220-24
TMP220-28
TMP220-19-C2
TMP220-24-C2
TMP220-28-C2
Class
I
I
I
II
II
II
Output
Voltage
19V
24V
28V
19V
24V
28V
Maximum
Maximum
Load
Output Power
10.53A
200W
9.17A
220W
7.86A
220W
10.53A
200W
9.17A
220W
7.86A
220W
Note:
1) Class I models are equipped with IEC320/C14 AC inlet.
2) Class II models are equipped with IEC320/C8 AC inlet.
Tumbler Technologies + TRUMPower
3350 Scott Blvd., Building 13 • Santa Clara, California 95054, USA • 408-988-6616 • [e-mail] • www.TRUMPower.com