TMP120 Datasheet, PDF (1/2 Pages) Tumbler Technologies + TRUMPower – 120 WATT MEDICAL POWER ADAPTERS

TRUMPower
120 WATT MEDICAL POWER ADAPTERS
DESCRIPTION
The TMP120 series of AC/DC switching power
adapters are for 96 to 120 watts of continuous
output power. They are enclosed in a 94V-1 rated
case with an IEC 320/C14 or C18 inlet to mate with
interchangeable AC power cord for world-wide
use. All models meet CISPR 11 and FCC class B
emission limits, and are designed for medical
applications.
TMP120 SERIES
Class I, Class II
(LVD)
RoHS
FEATURES
‧ Low safety ground leakage current
‧ Optional output connectors
‧ 100% burn-in
‧ 90 to 264VAC wide input range
‧ Overvoltage and overcurrent protections
‧ Optional IEC 320/C18 inlet with class II insulation
‧ Compliant with CEC and Energy Star efficiency
level IV requirements
‧ No load power consumption less than 0.5W
‧ Average active efficiency ≥85%
‧ Compliant with RoHS requirements
Safety Standard Approvals：
UL 60601-1
CSA C22.2 No. 601.1
TÜV EN60601-1
INPUT SPECIFICATIONS
Input voltage：
90 to 264VAC
Input frequency：
47 to 63Hz
Input current：
1.60A (rms) for 115 VAC
0.80A (rms) for 230 VAC
Earth leakage current：
(Class I)
90µA max. @ 115 VAC/60Hz
150µA max. @ 230 VAC/50Hz
E n c l o s u r e l e a k a g e c u r r e n t : ^{90µA max. @ 264 VAC/50Hz}
(Class II)
OUTPUT SPECIFICATIONS
Output voltage/current： See rating chart
Total output power：
120 watts maximum
Ripple and noise：
2% peak to peak maximum
Overvoltage protection： Provided on output #1 only;
set at 112 -140% of its nominal
output voltage
Overcurrent protection： All outputs protected to short
circuit conditions
Temperature coefficient： All outputs ±0.04%/ºC maximum
Transient response：
Maximum excursion of 4% or
better on all models, recovering
to 1% of final value within 500µs
after a 25% step load change
GENERAL SPECIFICATIONS
Switching frequency： 50KHz ~ 110KHz
Power factor：
0.98 typical at 115VAC
Efficiency：
85% min.
Hold-up time：
15 msec minimum at 115VAC
Line regulation：
±0.5% maximum at full load
Inrush current：
Withstand voltage：
MTBF：
60 amps @ 115VAC or 90 amps
@230VAC, at 25ºC cold start
4000VAC from input to output
1500VAC from input to ground
500VAC from output to ground
150,000 hours minimum at full load at
25ºC ambient, calculated per
MIL-HDBK-217F
EMC Performance (EN60601-1-2: 2001)
EN55011:
FCC:
Class B conducted, Class B radiated
Class B conducted, Class B radiated
VCCI:
EN61000-3-2:
EN61000-3-3:
Class B conducted, Class B radiated
Harmonic distortion, Class A and D
Line flicker
EN61000-4-2:
ESD, ±8KV air and ±6KV contact
EN61000-4-3:
Radiated immunity, 3V/m
EN61000-4-4:
Fast transient/burst, ±2KV
EN61000-4-5:
Surge, ±1KV diff, ±2KV com.
EN61000-4-6:
Conducted immunity, 3Vrms
ENVIRONMENTAL SPECIFICATIONS
O p e r a t i n g t e m p e r a t u r e ： 0 ºC t o + 6 0 ºC
S t o r a g e t e m p e r a t u r e ： - 4 0 ºC t o + 8 5 ºC
Relative humidity：
5% to 95% non-condensing
Derating：
Derate from 100% at +40ºC
EN61000-4-8:
EN61000-4-11:
Magnetic field immunity, 3A/m
Voltage dips, 30% reduction for 500ms,
60% reduction for 100ms and >95%
reduction for 10ms
linearly to 50% at +60ºC
Tumbler Technologies + TRUMPower
3350 Scott Blvd., Bldg. 13, Santa Clara, California 95054, USA
Phone: [phone] ● Fax: [phone] ● email: [e-mail] ● Website: www.TRUMPower.com