TMP105 Datasheet, PDF (1/2 Pages) Burr-Brown (TI) – Digital Temperature Sensor with Two-Wire Interface

TRUMPower
TMP105 Series
90-105 Watts Medical & ITE Power Adapters
FEATURES
• 90~264 VAC Input, Soft Start
• 0.98 Power Factor
• 87% to 91% Efficiency
• High Peak Power
• Low Safety Ground Leakage Current
• Class I & Class II Models Available
• Compliant with CEC & Energy Star Level V
INPUT SPECIFICATIONS
Input Voltage Range ............ 90~264 VAC
Input Frequency ................... 47~63Hz
Input Current ........................ 1.4A rms @ 115 VAC
0.7A rms @ 230 VAC
Inrush Current ..................... 80A @ 115 VAC or 120A @ 230 VAC,
at 25°C cold start
Soft Start ............................... Yes
Earth Leakage Current ........ 200µA max. @ 264 VAC, 63Hz
Touch Current ...................... 100µA max. @ 264 VAC, 63Hz
OUTPUT SPECIFICATIONS
Output Power Ratings .......... See table
Minimum Load ...................... Not required
Tolerance ............................. ±5%
Ripple and Noise* ............... 1% peak to peak max. at full load
Overvoltage Protection ........ Set at 115-140% of its nominal
output voltage
Overcurrent Protection ........ Protected to short-circuit
conditions
Temperature Coefficient ..... ±0.04%/°C max.
Transient Response ........... Max. excursion of 4% or better on
all models, recovering to 1% of
final value within 500 µs after a
25% step load change
* Measured with 20MHz bandwidth at rated line voltage and output load ranges, with
a 10µF tantalum capacitor in parallel with a 0.1µF ceramic capacitor in parallel
across the output.
GENERAL SPECIFICATIONS
Power Factor ....................... 0.98 typical @ 115 VAC
Efficiency ............................. 87% minimum at full load
Hold-up Time ....................... 10 ms at 110 VAC
Switching Frequency ........... 70~140KHz
Operating Temperature ...... 0°C to +60°C
Derating ............................... Derate from 100% at +40°C linearly
to 50% at +60°C
Storage Temperature .......... -40°C to +85°C
Relative Humidity ................ 5°C to +95°C non-condensing
Withstand Voltage ............... 5,656 VDC from input to output
(4,000 VAC for Class II models)
2,121 VDC from input to ground
707 VDC from output to ground
MTBF .................................... 150K hours minimum at full load,
25°C ambient, calculated per
MIL-HDBK-217F
MODELS LIST
Product No. ⁽¹⁾
Output
Voltage
Maximum
Current
Peak ⁽²⁾
Current
Maximum
Power
TMP105-12
12V
7.5A
15A
90W
TMP105-13
13V
6.93A
13.8A
90W
TMP105-15
14~16V
6.79A
13.58A
95W
TMP105-18
18~19V
5.84A
11.6A
105W
TMP105-20
20~21V
5.25A
10.5A
105W
TMP105-24
24~25V
4.38A
8.7A
105W
TMP105-28
28~29V
3.75A
4.5A
105W
TMP105-30
30~32V
3.5A
4.2A
105W
TMP105-36
36~38V
2.92A
3.5A
105W
TMP105-48
46~50V
2.29A
2.7A
105W
Notes:
1) The listed P/N's are for Class I models equipped with IEC 320/C14 AC inlet.
Add suffix "C2" to order Class II models equipped with IEC 320/C18 AC inlet.
When ordering 14-50V output units, specify the requested voltage, e.g. use P/N
TMP105-18.5-C2 to order 18.5V Class II model.
2) The peak current is for 10 seconds maximum with the average power not over the
maximum power.
STANDARDS & COMPLIANCES
IEC/EN 61000-1-2 ............. EMC & Immunity Performance
EN 55011, EN 55022 ........ Class B, conducted & radiated
FCC, VCCI ......................... Class B, conducted & radiated
EN 61000-3-2 .................... Harmonic distortion, Class A & D
EN 61000-3-3 .................... Line flicker
EN 61000-4-2 .................... ESD, ±8 KV air and ±6 KV contact
EN 61000-4-3 .................... Radiated immunity, 3V/m
EN 61000-4-4 .................... Fast transient/burst, ±2 KV
EN 61000-4-5 .................... Surge, ±1 KV diff., ±2 KV com.
EN 61000-4-6 .................... Conducted immunity, 3 Vrms
EN 61000-4-8 .................... Magnetic field immunity, 3A/m
EN 61000-4-11 .................. Voltage dip immunity,
30% reduction for 500ms,
60% reduction for 100ms,
>95% reduction for 10ms
Safety Standards ............... IEC/EN/UL 60601-1 (3rd Ed.),
ANSI/AAMI ES 60601-1 (1st Ed.),
CSA C22.2 No. 60601-1 (2nd Ed.),
IEC/EN 60950-1 (2nd Ed.)
Agency Approvals .............. UL, cUL, TUV, CE, CB
Other Compliances .......... RoHS, CEC & Energy Star Level V
Tumbler Technologies + TRUMPower
3350 Scott Blvd., Building 13 • Santa Clara, California 95054, USA • 408-988-6616 • [e-mail] • www.TRUMPower.com