TIPC500P Datasheet, PDF (1/1 Pages) Tumbler Technologies + TRUMPower – 500W High Efficiency PS/2 ATX IPC Power Supply

TIPC500P
500W High Efficiency PS/2 ATX IPC Power Supply
FEATURES
• PS/2 ATX Form Factor
• Complies with ATX12V Standard
• Meets 80PLUS Platinum Efficiency Level
• Active PFC meets EN 61000-3-2
• 5,000 Meters Operating Altitude
• Approved to UL/IEC/EN 60950-1 2nd Edition
INPUT SPECIFICATIONS
Input Voltage Range ................... 90-264 VAC
Input Frequency .......................... 47-63Hz
Input Current ............................... 8A rms max. @ 115 VAC
4A rms max. @ 230 VAC
Inrush Current ............................. 50A @ 115 VAC,
.................................................... 100A @ 230 VAC, at 25°C cold
.................................................... start
Earth Leakage Current ............... 350µA max. @ 264 VAC, 50Hz
OUTPUT SPECIFICATIONS
Output Power Ratings ................ See rating chart
Load Regulation ......................... See rating chart
Ripple & Noise* .......................... See rating chart
Hold-up Time .............................. 12ms min. @ 115 VAC, 60 Hz
.................................................... 16ms min. @ 230 VAC, 50 Hz
Rise Time .................................... 20ms max. @ 115/230VAC
Over Voltage Protection, +3.3V .. 3.5-4.8V
+5V ..... 5.5-7V
+12V ... 13.4-16V
Over Current Protection, +3.3V .. 35-60A
+5V ..... 30-45A
+12V ... 22-30A
Short Circuit Protection .............. Shut down & Latch off on
+3.3V/+5V/+12V; No damage
on -12V/-5V
Temperature Coefficient ............. ±0.04%/°C max.
* Measured with 20MHz bandwidth at rated line voltage and output load ranges,
with a 10µF tantalum capacitor in parallel with a 0.1µF ceramic disk capacitor
across the output connector.
GENERAL SPECIFICATIONS
Efficiency ............................ 92% typ. @ full load
Operating Altitude .............. 5,000 meters max.
Operating Temperature ...... 0°C to +50°C
Storage Temperature ......... -20°C to +80°C
Relative Humidity ............... 5% to 95% non-condensing
Withstand Voltage .............. 1,800 VAC, input-ground
MTBF ................................. 150K hours mininum at full load &
25°C ambient, calculated per
MIL-HDBK-217F
STANDARDS & COMPLIANCES
EMI/EMC ............................ FCC & CISPR 22, Class B conducted
FCC & EN 55022, Class B radiated
Safety Standards ............... UL/IEC/EN 60950-1 2nd Edition
Agency Approvals .............. UL, cUL, TUV, CCC, CB, CE
Other Compliance .............. 80PLUS, RoHS, EuP Lot 6:2013
MECHANICAL SPECIFICATIONS
OUTPUT VOLTAGE & CURRENT RATING CHART
Ouptut
Voltage
Minimum
Load
*Maximum
Load
Load
Ripple & Noise
Regulation
VP-P Max.
+3.3V
0.3A
24A
±5%
50mV
+5V
0.3A
20A
±5%
50mV
+12V1
0.3A
18A
±5%
120mV
+12V2
0.3A
18A
±5%
120mV
-12V
0A
0.5A
±10%
120mV
+5Vsb
0A
3A
±5%
50mV
*-5V
0A
0.2A
±10%
100mV
* The overall output power is 500W maximum.
* The total output power for +3.3V & +5V is 120W maximum.
* -5V output is optional.
Notes:
1. Dimensions in mm.
2. Power switch is optional.
3. Customized cable sets available upon request.
TIPC500P_2016-08-05
Tumbler Technologies + TRUMPower
3350 Scott Blvd., Building 13 • Santa Clara, California 95054, USA • 408-988-6616 • [e-mail] • www.TRUMPower.com