TIPC400-24 Datasheet, PDF (1/1 Pages) Tumbler Technologies + TRUMPower – 400W ATX PC Power Supply with 24V Output

TIPC400-24
400W ATX PC Power Supply with 24V Output
FEATURES
• Meets ATX12V Standard
• Additional 24V/5A Output
• Meets 80PLUS Bronze Efficiency Level
• Active PFC meets EN 61000-3-2 Standard
• Optional On/Off Switch
• Approved to IEC/EN/UL 60950-1 2nd Edition Standards
INPUT SPECIFICATIONS
Input Voltage Range ............ 90-264 VAC
Input Frequency ................... 47-63Hz
Input Current ........................ 8A rms max. @ 115 VAC
4A rms max. @ 230 VAC
Inrush Current ...................... 80A max. @ 115 VAC,
............................................. 160A max. @ 230 VAC,
at 25°C cold start
Earth Leakage Current ........ 350µA max. @ 264 VAC, 63Hz
OUTPUT SPECIFICATIONS
Output Power Ratings ................ See rating chart
Line Regulation ........................... ±0.5% max. at full load
Load Regulation ......................... See rating chart
Ripple & Noise* .......................... See rating chart
Hold-up Time .............................. 15ms min. @ 115/230 VAC
Rise Time .................................... 20ms, 10-90% of the rated
output @ full load, 115/230V
Over Voltage Protection, +3.3V .. 3.7-4.8V
+5V ..... 5.7-7V
+12V ... 13.3-16V
+24V ... 27-31V
Over Current Protection, +3.3V .. 25-50A
+5V ..... 25-45A
+12V ... 20-28A for each rail
+24V ... 8-13A
Short Circuit Protection .............. On all outputs, Latch off except
auto-recovery on 5Vsb
Temperature Coefficient ............. ±0.04%/°C max.
* Measured with 20MHz bandwidth at rated line voltage and output load ranges,
with a 10µF tantalum capacitor in parallel with a 0.1µF ceramic disk capacitor
across the output connector.
GENERAL SPECIFICATIONS
Efficiency ............................ 85% typical; 82% min. @ full load
Operating Temperature ...... 0°C to +50°C
Storage Temperature ......... -20°C to +80°C
Relative Humidity ............... 5% to 95% non-condensing
MTBF ................................. 100K hours mininum at full load &
25°C ambient, calculated per
MIL-HDBK-217F
STANDARDS & COMPLIANCES
EMI/EMC ............................ FCC & CISPR 22, Class B conducted
FCC & EN 55022, Class B radiated
Safety Standards ............... UL/IEC/EN 60950-1 2nd Edition
Agency Approvals .............. UL, cUL, TUV, CB, CE
Other Compliance .............. 80PLUS, RoHS, EuP Lot 6:2013
MECHANICAL SPECIFICATIONS
OUTPUT VOLTAGE & CURRENT RATING CHART
Ouptut
Voltage
Minimum
Load
*Maximum
Load
Load
Ripple & Noise
Regulation
VP-P Max.
+3.3V
0.5A
16A
±5%
50mV
+5V
0.5A
16A
±5%
50mV
+12V1
0.5A
16A
±5%
120mV
+12V2
0.5A
16A
±5%
120mV
Notes:
1. Dimensions in mm.
2. Cutomized cable set available upon request.
+24V
0.2A
5A
±10%
200mV
-12V
0A
0.5A
±10%
120mV
+5Vsb
0A
3A (3.5A Peak)
±5%
50mV
*-5V
0A
0.3A
±10%
100mV
* The overall output power is 400W maximum.
* The total output power for +3.3V & +5V is 130W maximum.
* -5V output is optional.
TIPC400-24_2016-06-20
Tumbler Technologies + TRUMPower
3350 Scott Blvd., Bluilding 13 • Santa Clara, California 95054, USA • 408-988-6616 • [e-mail] • www.TRUMPower.com