TIPC350-1U Datasheet, PDF (1/1 Pages) Tumbler Technologies + TRUMPower – 350W 1U ATX12V IPC Power Supply

TIPC350-1U
350W 1U ATX12V IPC Power Supply
FEATURES
• 1U Form Factor
• Meets ATX12V Standard
• 80PLUS Efficiency Level
• Active PFC meets EN 61000-3-2 Standard
• Remote ON/OFF Function
• Approved to UL/IEC/EN 60950-1 2nd Edition
INPUT SPECIFICATIONS
Input Voltage Range ................... 90-264 VAC
Input Frequency .......................... 47-63Hz
Input Current ............................... 6A rms max. @ 115 VAC
.................................................... 3A rms max. @ 230 VAC
Inrush Current ............................. 50A @ 115 VAC,
.................................................... 100A @ 230 VAC, at 25°C cold
.................................................... start
Earth Leakage Current ............... 350µA max. @ 264 VAC, 50Hz
OUTPUT SPECIFICATIONS
Output Power Ratings ................ See rating chart
Load Regulation ......................... See rating chart
Ripple & Noise* .......................... See rating chart
Hold-up Time .............................. 17ms min. @ 115/230VAC
Rise Time .................................... 20ms max. @ 115/230VAC
Over Voltage Protection, +3.3V .. 3.7-4.8V
+5V ..... 5.5-6.82V
+12V ... 13.4-15.6V
Over Current Protection, +3.3V .. 50mV p-p
+5V ..... 50mV p-p
+12V ... 120mV p-p
-12V .... 120mV p-p
+5Vsb . 50mV p-p
-5V ...... 100mV p-p
Short Circuit Protection .............. On all outputs, Load of less
.................................................... than 0.1 ohm
Temperature Coefficient ............. ±0.04%/°C max.
* Measured with 20MHz bandwidth at rated line voltage and output load ranges,
with a 10µF tantalum capacitor in parallel with a 0.1µF ceramic disk capacitor
across the output connector.
OUTPUT VOLTAGE & CURRENT RATING CHART
Ouptut
Voltage
Minimum
Load
*Maximum
Load
Load
Ripple & Noise
Regulation
VP-P Max.
+3.3V
0.5A
16A
±5%
50mV
+5V
0.5A
18A
±5%
50mV
+12V1
1A
16A
±5%
120mV
+12V2
1A
16A
±5%
120mV
-12V
0A
0.8A
±10%
120mV
+5Vsb
0A
2.5A
±5%
50mV
-5V
0A
0.3A
±10%
100mV
* The overall output power is 350W maximum.
* The total output power for +3.3V & +5V is 130W maximum.
* The total output current for +12V1 & +12V2 is 24A maximum.
GENERAL SPECIFICATIONS
Efficiency ............................ 84% typ. @ full load
Operating Altitude .............. 2,000 meters max.
Operating Temperature ...... 0°C to +50°C
Storage Temperature ......... -20°C to +80°C
Relative Humidity ............... 5% to 95% non-condensing
Withstand Voltage .............. 1,800 VAC, input-ground
MTBF ................................. 150K hours mininum at full load &
25°C ambient, calculated per
MIL-HDBK-217F
STANDARDS & COMPLIANCES
EMI/EMC ............................ FCC & CISPR 22, Class B conducted
FCC & EN 55022, Class B radiated
Safety Standards ............... UL/IEC/EN 60950-1 2nd Edition
Agency Approvals .............. UL, cUL, TUV, CB, CE, CCC
Other Compliance .............. 80PLUS, RoHS
MECHANICAL SPECIFICATIONS
Notes:
1. Dimensions in mm.
2. Customized cable set available upon request.
TIPC350-1U_2016-08-18
Tumbler Technologies + TRUMPower
3350 Scott Blvd., Building 13 • Santa Clara, California 95054, USA • 408-988-6616 • [e-mail] • www.TRUMPower.com