TIPC300BE Datasheet, PDF (1/1 Pages) Tumbler Technologies + TRUMPower – 300W PS/2 ATX IPC Power Supply

TIPC300BE
300W PS/2 ATX IPC Power Supply
FEATURES
• PS/2 ATX Form Factor
• Complies with ATX12V Standard
• Meets 80PLUS Bronze Efficiency Level
• Active PFC meets EN 61000-3-2 Standard
• Remote ON/OFF Function
• Approved to UL/IEC/EN 60950-1 2nd Edition
INPUT SPECIFICATIONS
Input Voltage Range ................... 90-264 VAC
Input Frequency .......................... 47-63Hz
Input Current ............................... 6A rms max. @ 115 VAC
3A rms max. @ 230 VAC
Earth Leakage Current ............... 350µA max. @ 264 VAC, 63Hz
OUTPUT SPECIFICATIONS
Output Power Ratings ................ See rating chart
Load Regulation ......................... See rating chart
Ripple & Noise* .......................... See rating chart
Hold-up Time .............................. 17ms min. @ 115/230 VAC
Rise Time .................................... 20ms max. @ 115/230 VAC
Over Voltage Protection, +3.3V .. 3.76-6V
+5V ..... 5.74-7V
+12V ... 13.4-15.6V
Over Current Protection, +3.3V .. 50mV p-p
+5V ..... 50mV p-p
+12V ... 120mV p-p
-12V .... 120mV p-p
+5Vsb . 50mV p-p
Short Circuit Protection .............. On all outputs, Load of less
.................................................... than 0.1 ohm
Temperature Coefficient ............. ±0.04%/°C max.
* Measured with 20MHz bandwidth at rated line voltage and output load ranges,
with a 10µF tantalum capacitor in parallel with a 0.1µF ceramic disk capacitor
across the output connector.
OUTPUT VOLTAGE & CURRENT RATING CHART
Ouptut
Voltage
Minimum
Load
*Maximum
Load
Load
Ripple & Noise
Regulation
VP-P Max.
+3.3V
0.1A
21A
±5%
50mV
+5V
0.2A
15A
±5%
50mV
+12V1
0.1A
11A
±5%
120mV
+12V2
0.5A
8A
±5%
120mV
-12V
0A
0.3A
±10%
120mV
+5Vsb
0A
2.5A
±5%
50mV
* The overall output power is 300W maximum.
* The total output power for +3.3V & +5V is 130W maximum.
* +12V2 supports processor power requirements and must have a separate current
limit and provide 13A peak current for 10ms, minimum voltage during peak is
>10.8VDC.
GENERAL SPECIFICATIONS
Efficiency ............................ 85% typ. @ full load
Operating Altitude .............. 2,000 meters max.
Operating Temperature ...... 0°C to +50°C
Storage Temperature ......... -20°C to +80°C
Relative Humidity ............... 5% to 95% non-condensing
Withstand Voltage .............. 1,800 VAC, input-ground
MTBF ................................. 150K hours mininum at full load &
25°C ambient, calculated per
MIL-HDBK-217F
STANDARDS & COMPLIANCES
EMI/EMC ............................ FCC & CISPR 22, Class B conducted
FCC & EN 55022, Class B radiated
Safety Standards ............... UL/IEC/EN 60950-1 2nd Edition
Agency Approvals .............. UL, cUL, TUV, CB, CE, CCC
Other Compliance .............. 80PLUS, RoHS
MECHANICAL SPECIFICATIONS
Notes:
1. Dimensions in mm.
2. Power switch is optional.
2. Customized cable sets available upon request.
TIPC300BE_2016-08-07
Tumbler Technologies + TRUMPower
3350 Scott Blvd., Building 13 • Santa Clara, California 95054, USA • 408-988-6616 • [e-mail] • www.TRUMPower.com