S1A Datasheet, PDF (1/2 Pages) Pan Jit International Inc. – SURFACE MOUNT RECTIFIER(VOLTAGE - 50 to 1000 Volts CURRENT - 1.0 Ampere)

S1A THRU S1M
SURFACE MOUNT RECTIFIER
VOLTAGE - 50 to 1000 Volts CURRENT - 1.0 Ampere
FEATURES
l For surface mounted applications
l High temperature metallurgically bonded-no
compression contacts as found in other
diode-constructed rectifiers
l Glass passivated junction
l Built-in strain relief
l Easy pick and place
l Plastic package has Underwriters Laboratory
Flammability Classification 94V-O
l Complete device submersible temperature of
260for 10 seconds in solder bath
SMA/DO-214AA
MECHANICAL DATA
Case: JEDEC DO-214AA molded plastic
Terminals: Solder plated, solderable per MIL-STD-750,
Method 2026
Polarity: Indicated by cathode band
Standard packaging: 12mm tape (EIA-481)
Weight: 0.003 ounce, 0.093 gram
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25 ambient temperature unless otherwise specified.
Single phase, half wave, 60 Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
SYMBOLS S1A S1B S1D S1G S1J
Maximum Recurrent Peak Reverse Voltage
Maximum RMS Voltage
Maximum DC Blocking Voltage
Maximum Average Forward Rectified Current,
at T_L=100
Peak Forward Surge Current 8.3ms single half sine-
wave superimposed on rated load(JEDEC method)
Maximum Instantaneous Forward Voltage at 1.0A
Maximum DC Reverse Current T_A=25
At Rated DC Blocking Voltage T_A=125
Maximum Reverse Recovery Time (Note 1)
Typical Junction capacitance (Note 2)
Typical Thermal Resistance (Note 3)
Operating and Storage Temperature Range
V_RRM
V_RMS
V_DC
I_(AV)
I_FSM
V_F
I_R
T_RR
C_J
RJL
T_J,T_STG
50 100 200 400 600
35 70 140 280 420
50 100 200 400 600
1.0
30.0
1.10
5.0
50
2.5
12
30.0
-55 to +150
NOTES:
1.Reverse Recovery Test Conditions: I_F=0.5A, I_R=1.0A, Irr=0.25A
2.Measured at 1 MHz and Applied Vr=4.0 volts
3.8.0mm² (.013mm thick) land areas
S1K S1M UNITS
800 1000 Volts
560 700 Volts
800 1000 Volts
Amps
Amps
Volts
A
S
P^F
/W