CP800 Datasheet, PDF (1/2 Pages) Pan Jit International Inc. – SINGLE-PHASE SILICON BRIDGE(VOLTAGE - 50 to 800 Volts CURRENT - P.C. MTG 3A, HEAT-SINK MTG 8A)

CP800 THRU CP808
SINGLE-PHASE SILICON BRIDGE
VOLTAGE - 50 to 800 Volts CURRENT - P.C. MTG 3A, HEAT-SINK MTG 8A
CP-8
FEATURES
l Surge overload rating—200 Amperes peak
l Low forward voltage drop and reverse leakage
l Small size, simple installation
l Plastic package has Underwriter Laboratory
Flammability Classification 94V-O
l Reliable low cost construction utilizing molded
plastic technique
MECHANICAL DATA
Mounting position: Any
Weight: 0.24 ounce, 6.9 grams
Terminals: Leads solderable per MIL-STD-202,
Method 208
Mounting torque: Thro hole for #6 screw
MACXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
At 25 ambient temperature unless otherwise noted; resistive or inductive load at 60Hz .
Max Recurrent Peak Reverse Voltage
Max Bridge Input Voltage RMS
Max Average Rectified Output at T_C=50 *
See Fig. 2
at T_A=40 **
Peak One Cycle Surge Overload Current
Max Forward Voltage Drop per element at
4.0A DC & 25 . See Fig. 3
Max Rev Leakage at rated Dc Blocking
Voltage per element at 25
See Fig 4
at100
I²t Rating for fusing ( t<8.3ms)
Typical junction capacitance per leg (Note 4) CJ
Typical Thermal Resistance per leg (Note 3) R JA
Typical Thermal Resistance per leg (Note 2) R JL
Operating Temperature Range
Storage Temperature Range
CP800
50
35
CP801
100
70
CP802 CP804
200
400
140
280
8.0
3.0
200
1.1
CP806
600
420
10.0
1.0
166
200
21
6
-55 TO +125
-55 TO +150
CP808
800
560
UNITS
V
V
A
A
A
V
A
mA
A²Sec
P^F
/W
NOTES:
1. Bolt down on heat-sink with silicon thermal compound between bridge and mounting surface
for maximum heat transfer with #6 screw.
2. Units Mounted on a 8.6”×8.6” ×24” thick (22×22×0.6cm) AL plate heatsink.
3. Units Mounted on P.C.B at 0.375”(9.5mm) lead length with 0.5×0.5”(12×12mm)copper pads.