CP300 Datasheet, PDF (1/2 Pages) Pan Jit International Inc. – SINGLE-PHASE SILICON BRIDGE-P.C. MTG 2A, HEAT-SINK MTG 3A(VOLTAGE - 50 to 1000 Volts CURRENT - 3.0 Amperes)

CP300 THRU CP3010
SINGLE-PHASE SILICON BRIDGE-P.C. MTG 2A, HEAT-SINK MTG 3A
VOLTAGE - 50 to 1000 Volts CURRENT - 3.0 Amperes
CP-3
FEATURES
l Surge overload rating—50 Amperes peak
l Low forward voltage drop and reverse leakage
l Small size, simple installation
l Plastic package has Underwriter Laboratory
Flammability Classification 94V-O
l Reliable low cost construction utilizing molded
plastic technique
MECHANICAL DATA
Terminals: Leads solderable per MIL-STD-202,
Method 208
Weight: 0.08 ounce, 2.5 grams
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
At 25 ambient temperature unless otherwise noted; resistive or inductive load at 60Hz.
CP300 CP301 CP302 CP304 CP306
Max Recurrent Peak Rev Voltage
50
Max Bridge Input Voltage RMS
35
Max Average Rectified Output at T_C=50 *
See Fig.2
at T_A=25 **
Peak One Cycle Surge Overload Current
Max Forward Voltage Drop per element at
1.5A DC & 25 . See Fig.3
Max Rev Leakage at Rated DC Blocking
Voltage per element at 25
See Fig.4
at 100
I²t Rating for fusing ( t<8.3ms)
Typical Junction capacitance per leg(Note 4)CJ
Typical Thermal Resistance per leg(Note 2) R JA
(Note 3) R JL
Operating Temperature Range
Storage Temperature Range
100 200 400 600
70 140 280 420
3.0
2.0
50
1.0
10.0
1.0
15.0
21.0
12.0
8.0
-55 TO +125
-55 TO +150
CP308
800
560
CP3010 UNITS
1000 V
700 V
A
A
V
A
mA
A²Sec
P^F
/W
NOTES:
1. Bolt down on heat-sink with silicon thermal compound between bridge and mounting surface for
maximum heat transfer with #6 screw.
2. Unit mounted on 4.0×4.0×0.11” thick (10.5×10.5×0.3cm) AL. Plate.
3. Unit mounted on P.C.B at 0.375”(9.5mm) lead length with 0.5×0.5” (12×12mm) copper pads.
4. Measured at 1 MHz and applied reverse voltage of 4.0 Volts.