CP1000 Datasheet, PDF (1/2 Pages) Pan Jit International Inc. – SINGLE-PHASE SILICON BRIDGE(VOLTAGE - 50 to 800 Volts CURRENT - P.C. MTG 3A, HEAT-SINK MTG 10A)

CP1000 THRU CP1008
SINGLE-PHASE SILICON BRIDGE
VOLTAGE - 50 to 800 Volts CURRENT - P.C. MTG 3A, HEAT-SINK MTG 10A
FEATURES
l Surge overload rating—200 Amperes peak
l Low forward voltage drop and reverse leakage
l Small size, simple installation
l Plastic package has Underwriter Laboratory
Flammability Classification 94V-O
l Reliable low cost construction utilizing molded
plastic technique
CP-10
MECHANICAL DATA
Case: Molded plastic with heatsink integrally
mounted in the bridge encapsulation
Terminals: Leads solderable per MIL-STD-202,
Method 208
Weight: 0.21 ounce, 6.1 grams
MACXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
At 25 ambient temperature unless otherwise noted; resistive or inductive load at 60Hz .
Max Recurrent Peak Rev Voltage
Max Bridge Input Voltage RMS
Max Average Rectified Output at T_C=50 *
See Fig. 2
at T_C=100 *
at T_A=50 **
Peak One Cycle Surge Overload Current
Max Forward Voltage Drop per element at
5.0A DC & 25 . See Fig. 3
Max Rev Leakage at rated Dc Blocking
Voltage per element at 25
See Fig 4
at100
Typical junction capacitance per leg (Note 4) CJ
I²t Rating for fusing ( t<8.3ms)
Typical Thermal Resistance (Note 2) R JA
Typical Thermal Resistance (Note 3) R JC
Operating Temperature Range
Storage Temperature Range
CP1000
50
35
CP1001
100
70
CP1002 CP1004
200
400
140
280
10.0
3.0
3.0
200
1.1
CP1006
600
420
CP1008
800
560
UNITS
V
V
A
A
A
V
10.0
A
1.0
mA
200
P^F
164
A²S
25
/W
5
-55 TO +125
-55 TO +150
NOTES:
* Unit mounted on metal chassis.
** Unit mounted on P.C. board.
1. Recommended mounting position is to bolt down on heatsink with silicone thermal compound
for maximum heat transfer with #6 screw.
2. Units Mounted in free air, no heatsink. P.C.B at 0.375”(9.5mm) lead length with 0.5×0.5”