TQM7M9023 Datasheet, PDF (8/15 Pages) TriQuint Semiconductor – 5.0x7.5mm Multimode Multiband Power Amplifier

TQM7M9023
Data Sheet
5.0x7.5mm Multimode Multiband Power Amplifier (MMPA)
(Quad-Band GSM / EDGE and Tri-band W/CDMA/HSPA+/LTE)
RF Electrical Characteristics – Band 5 ^{1, 2}
Parameter
Power Mode Conditions
Min Typ Max
Unit
Frequency
All modes UMTS Band 5
824
849
MHz
HPM
WCDMA Rel99 waveform (TC1)
28.25
dBm
Maximum Output Power ³
HPM
Worst case 3GPP; MPR = 0 dB (TC2)
HPM
LTE, MPR=0dB
27.25
27.25
dBm
dBm
HPM
CDMA EVDO revA modulation
27
dBm
HPM
POUT ≤ max power
27.6
dB
Gain
MPM
POUT ≤ 17dBm (16dBm 3GPP MPR = 0)
18
dB
LPM
POUT ≤ 9dBm ( 6dBm 3GPP MPR = 0)
11.7
dB
Noise Power in Rx Band
All modes 190 MHz offset from Tx at all powers
-133
dBm/Hz
Quiescent Current (IcQ)
MPM
LPM
No RF Applied
15
mA
5
mA
Supply Current
HPM
POUT = 28.25 dBm
LPM
POUT = 3.5dBm
460
mA
8
mA
Error Vector Magnitude (EVM)
POUT ≤ (maximum power – MPR)
POUT ≤ (maximum power – MPR – 3 dB)
3.35
% rms
2.5
% rms
UMTS Adjacent Channel
Leakage power Ratio (ACLR)
All modes4
± 5 MHz, POUT ≤ (maximum power - MPR)
± 10 MHz, POUT ≤ (maximum power - MPR)
-36
dBc
-46
dBc
LTE Adjacent Channel
Leakage Power Ratio (ACLR)
All modes
E-UTRAACLR; POUT ≤ (27dBm – MPR)
UTRAACLR1; POUT ≤ (27dBm – MPR)
UTRAACLR2; POUT ≤ (27dBm – MPR)
-33
dBc
-36
dBc
-39
dBc
Adjacent Channel Power
Ratio (ACPR)
HPM ≤ 27dBm
MPM ≤ 17dBm
LPM ≤ 8 dBm
± 885kHz; Pout ≤ 27dBm
± 1.98MHz; Pout ≤ 27dBm
-44 dBc/30KHz
-56 dBc/30kHz
Harmonic Suppression
H2
Pout ≤ maximum power
-35
dBc
Harmonic Suppression
H3 and higher Pout ≤ maximum power
-42
dBc
GPS Noise
All modes 1574 – 1577 MHz
-140
dBm/Hz
GPS Band Gain
Where G is gain in Tx band
G-25
dB
ISM Noise
All modes 2400 – 2483.5 MHz
-143
dBm/Hz
ISM Band Gain
Where G is gain in Tx band
G-30
dB
Input Impedance VSWR
All modes No external matching
2:1
Stability (all spurious)
All modes Load VSWR ≤ 5:1 in band, all phases
-70
dBc
Coupling Factor
All modes
20
dB
Note 1: RF measurements under the following conditions unless otherwise specified: VCC=3.4V, T=25 , Zin/Zout=50ohm, Rel99
waveform. All measurements are based upon tuning optimized for Band 5 performance. Please see application note for more information.
Note 2: RF measurements shall be made with 3GPP (UTRAN/FDD UE) TS25.101 specification compliant waveforms. (a) Rel99 waveform
(all beta_c, beta_d combinations) has very low peak-to-average power ratio and has its own requirement. MPR is the maximum power
reduction, worse case MPR = 0dB waveforms across UMTS technologies are required to meet a 1 dB lower maximum power than Rel99.
Signal Configuration: 3GPP (DPCCH + 1DPDCH) Up-Link unless specified otherwise.
Note 3: For VCC < 3.4V operation, up to a 0.5dB back-off is allowed for maximum power output. For VCC=3.4V, T=85°C, up to a 0.5dB back-off is
allowed for maximum power output.
Data Sheet
8
For additional information and the latest specifications, see our website: www.triquint.com
Revision F,September, 2011