ECG001B_15 Datasheet, PDF (3/5 Pages) TriQuint Semiconductor – InGaP HBT Gain Block

ECG001B
InGaP HBT Gain Block
Recommended Application Circuit
Vcc
Icc = 30 mA
R4
Bias
Resistor
C4
Bypass
Capacitor
C3
0.018 µF
RF IN
C1
Blocking
Capacitor
L1
RF Choke
ECG001B
RF OUT
C2
Blocking
Capacitor
ECG001B-PCB
Reference
Designator
L1
C1, C2, C4
50
820 nH
.018 µF
Recommended Component Values
Frequency (MHz)
500
900 1900 2200
220 nH 68 nH 27 nH 22 nH
1000 pF 100 pF 68 pF 68 pF
2500
18 nH
56 pF
3500
15 nH
39 pF
1. The proper values for the components are dependent upon the intended frequency of operation.
2. The following values are contained on the evaluation board to achieve optimal broadband performance:
Ref. Desig.
L1
C1, C2
C3
C4
R4
Value / Type
39 nH wirewound inductor
56 pF chip capacitor
0.018 µF chip capacitor
Do Not Place
51Ω 1% tolerance
Size
0603
0603
0603
0805
Recommended Bias Resistor Values
Supply
Voltage
R1 value
Size
5V
53.3 ohms
0805
6V
86.7 ohms
0805
8V
153 ohms
1210
9V
187 ohms
1210
10 V
220 ohms
2010
12 V
287 ohms
2010
The proper value for R1 is dependent upon the supply
voltage and allows for bias stability over temperature.
WJ recommends a minimum supply bias of +5 V. A
1% tolerance resistor is recommended.
Specifications and information are subject to change without notice
TriQuint Semiconductor, Inc • Phone [phone] • FAX: [phone] • e-mail: [e-mail] • Web site: www.TriQuint.com
Page 3 of 5 August 2011