TQL9043_15 Datasheet, PDF (2/10 Pages) TriQuint Semiconductor – 1500 to 2700 MHz Bypass LNA

TQL9043
1500 – 2700 MHz Bypass LNA
Absolute Maximum Ratings
Parameter
Rating
Storage Temperature
−65 to +150 °C
Drain Voltage (V_DD)
Input Power (CW)
+7 V
+24 dBm
Operation of this device outside the parameter ranges
given above may cause permanent damage.
Recommended Operating Conditions
Parameter
Min Typ Max Units
Drain Voltage (V_DD)
+3.3 +5.0 +5.25 V
Operating Temp. Range −40
T_ch (for>10⁶ hrs MTTF)
+85 °C
+190 °C
Electrical specifications are measured at specified test conditions.
Specifications are not guaranteed over all recommended operating
conditions.
Electrical Specifications
Test conditions unless otherwise noted: V_DD = +5 V, Temp. = +25 °C. Tested in an unmatched 50 Ω fixture.
Input trace loss up to package pin de-embedded on noise figure data.
Parameter
Conditions
Min Typ Max
Operational Frequency Range
1500
2700
Test Frequency
1900
Gain
Bypass OFF, LNA ON
16
17.5
19
Input Return Loss
Bypass OFF, LNA ON
7.2
Output Return Loss
Bypass OFF, LNA ON
13
Noise Figure
Bypass OFF, LNA ON
0.6
0.9
Output P1dB
Bypass OFF, LNA ON
+19.4
Output IP3
Bypass OFF, LNA ON
Pout=+5 dBm / tone, Δf=1 MHz
+28.5
+33
Insertion Loss
Bypass ON, LNA OFF
1.6
3.0
Return Loss
Bypass ON, LNA OFF
10
Input IP3
Bypass ON, LNA OFF
Pin = +6.5 dBm / tone, Δf=1 MHz
+41
Isolation
LNA OFF, Bypass OFF
13.5
Drain Voltage, V_DD
+5
Control Voltage, V1, V2 ⁽¹⁾
V_IH
V_IL
2.4
V_DD
0
0.4
Current, I_D
LNA ON, Bypass OFF
40
80
120
Current, I_D
Bypass ON, LNA OFF
3
Switching Speed
Bypass to LNA Mode
LNA to Bypass Mode
960
76
Thermal Resistance, θ_jc
Channel to case
44
Notes:
1. The limits shown are true when using the external resistive divider values as shown on the TriQuint app board.
Units
MHz
MHz
dB
dB
dB
dB
dBm
dBm
dB
dB
dBm
dB
V
V
V
mA
mA
ns
ns
°C/W
Control Truth Table
V_CTRL2
Low
High
Low
High
V_CTRL1
High
High
Low
Low
State
LNA OFF, Bypass OFF
LNA OFF, Bypass ON
LNA ON, Bypass OFF
Reserved (Do not use)
Control Voltage Limits (at device pins)
V_CTRL1
V_CTRL2
State
Low
High
Low
High
Bias Condition
≤ 0.1 V
≥ 0.52 V
≤ 0.4 V
≥ 1.3 V
Datasheet: Rev. F 09-25-14
© 2014 TriQuint
- 2 of 10 -
Disclaimer: Subject to change without notice
www.triquint.com