857162_15 Datasheet, PDF (2/5 Pages) TriQuint Semiconductor – 1000 MHz SAW Non Dispersive Delay Line

857162
1000 MHz SAW Non Dispersive Delay Line
Specifications
Electrical Specifications ⁽¹⁾
Specified Temperature Range: ⁽²⁾ -55 to +85 ºC
Parameter ⁽³⁾
Conditions
Center Frequency
Insertion Loss
700 – 1300 MHz
3 dB Bandwidth
Amplitude Variation ⁽⁵⁾
700 – 1300 MHz
Absolute Delay
Absolute Attenuation ⁽⁶⁾
10 – 450 MHz
1625 – 2000 MHz
Input VSWR
700 – 1300 MHz
Output VSWR
Source Impedance (single-ended) ⁽⁷⁾
Load Impedance (single-ended) ⁽⁷⁾
700 – 1300 MHz
Min
-
-
675
-
-
70
70
-
-
-
-
Typical ⁽⁴⁾
1000
30
700
1.1
1.5
82
76
4.75:1
4.85:1
50
50
Max
-
34
-
2.5
-
-
-
5.5:1
5.5:1
-
-
Units
MHz
dB
MHz
dB
µs
dB
dB
Ω
Ω
Notes:
1. All specifications are based on the TriQuint schematic for the main reference design shown on page 3.
2. In production, devices will be tested at room temperature to a guardbanded specification to ensure electrical compliance over
temperature.
3. Electrical margin has been built into the design to account for the variations due to temperature drift and manufacturing tolerances.
4. Typical values are based on average measurements at room temperature.
5. Is defined as the difference between the maximum and minimum loss within the specified frequency range.
6. Relative to 0 dB.
7. This is the optimum impedance in order to achieve the performance shown.
Absolute Maximum Ratings
Parameter
Operating Temperature
Storage Temperature
Rating
-55 to +85 ^oC
-55 to +105 ^oC
Operation of this device outside the parameter ranges given above may cause permanent damage.
Preliminary Data Sheet: Rev - 6/28/12
© 2012TriQuint Semiconductor, Inc.
- 2 of 5 -
Disclaimer: Subject to change without notice
Connecting the Digital World to the Global Network