TC2000 Datasheet, PDF (3/9 Pages) Tripath Technology Inc. – STEREO CLASS-T™ AUDIO CONTROLLER USING DIGITAL POWER PROCESSING (DPP™) TECHNOLOGY

Tripath Technology, Inc. - Technical Information
TC2000 AUDIO SIGNAL PROCESSOR PIN DESCRIPTIONS
Pin
1
2, 6
3
4, 7
5
8
9, 12
10, 11
13
14,16
15
17
18
19
20
21
22, 27
23, 28
Function
BIASCAP
FDBKP2, FDBKP1
DCMP
FDBKN2, FDBKN1
VPWR
HMUTE
Y1, Y2
Y1B, Y2B
NC
OCD2, OCD1
REF
VNNSENSE
OVRLDB
VPPSENSE
AGND
V5
OAOUT1, OAOUT2
INV1, INV2
24 MUTE
25, 26 BBM1, BBM0
Description
Bandgap reference times two (typically 2.5VDC). Used to set the common mode voltage
for the input op amps. This pin is not capable of driving external circuitry.
Positive switching feedback.
Internal mode selection. This pin must be grounded for proper device
operation.
Negative switching feedback.
Test pin. Must be left floating.
Logic output. A logic high indicates both amplifiers are muted, due to the mute pin state, or
a “fault”.
Non-inverted switching modulator outputs.
Inverted switching modulator outputs.
No connect
Over Current Detect. Ground if not used.
Internal reference voltage; approximately 1.2 VDC.
Negative power stage over/under supply voltage sense resistor tie point.
A logic low output indicates the input signal has overloaded the amplifier.
Positive power stage over/under supply voltage sense resistor tie point.
Ground
5 Volt power supply input.
Input stage output pins.
Single-ended inputs. Inputs are a “virtual” ground of an inverting opamp with
approximately 2.4VDC bias.
When set to logic high, both amplifiers are muted and in idle mode. When low (grounded),
both amplifiers are fully operational. If left floating, the device stays in the mute mode.
Ground if not used.
Break-before-make timing control.
TC2000 AUDIO SIGNAL PROCESSOR PINOUT
BIASCAP
1
28
FDBKP2
2
27
DCMP
3
26
FDBKN2
4
25
VPWR
5
24
FDBKP1
6
23
FDBKN1
7
22
HMUTE
8
21
Y1
9
20
Y1B
10
19
Y2B
11
18
Y2
12
17
NC
13
16
OCD2
14
15
INV2
OAOUT2
BBM0
BBM1
MUTE
INV1
OAOUT1
V5
AGND
VPPSENSE
OVRLDB
VNNSENSE
OCD1
REF
3
TC2000 – KLI/1.1/12-03