TMCM-342 Datasheet, PDF (1/1 Pages) TRINAMIC Motion Control GmbH & Co. KG. – 3-Axis Step/Direction Controller

MODULES FOR STEPPER MOTORS
10 mm
MODULES
TMCM-342
3-Axis
Step / Direction
Controller
INFO The TMCM-342 is a triple axis stepper motor controller module
for external power drivers with step / direction interface. With
its very small size it is dedicated to embedded applications,
where de-centralized high power drivers are desired. The board
can be connected to a baseboard or customized electronics
with a pin connector. The TMCM-342 comes with the PC based
software development environment TMCL-IDE for the Trinamic
Motion Control Language (TMCL). Using predefined TMCL high
level commands like „move to position“ or „constant rotation“
rapid and fast development of motion control applications is
guaranteed. The TMCM-342 can be controlled via the serial UART
interface (e.g. using a RS-232 or RS-485 level shifter), via CAN or
optinal via USB. Communication traffic is kept very low since all
time critical operations, e.g. ramp calculation, are performed on
board. The TMCL operations can be stored in the on board
EEPROM for stand-alone operation. An optional firmware allows
to control the TMCM-342 via CANopen. The firmware of the
module can be updated via the serial or via CAN interface.
TMCM-342
16
I/Os
CAN
RS-232
or
RS-485
5V DC
UART
TMCL
Memory
3x
programmable
Motion
Controller
with TMC428
6
step/dir
Driver
e.g. TMCM-035
step/dir
Driver
e.g. TMCM-035
step/dir
Driver
e.g. TMCM-035
REF-Switches
Step
Motor
Step
Motor
Step
Motor
MAIN CHARACTERISTICS
ELECTRICAL • 5V DC logic supply voltage
DATA
• TTL / CMOS step / direction outputs
SUPPORTED
DRIVERS
• step / direction drivers
(e.g. TMC401, TMCM-013, TMCM-023,
TMCM-078, IDX7505 or TMCM-171)
INTERFACE
• UART (RS-232, RS-485, up to 115200 bit/s) or
CAN 2.0b host interface (up to 1 Mbit/s) or
USB (optional)
• inputs for reference and stop switches
• general purpose analog and digital I/Os
FEATURES • three motion controllers
for high step frequency
• memory for 2048 TMCL commands
• ready for CANopen
• automatic ramp generation in hardware
• on the fly alteration of motion parameters
(e.g. position, velocity, acceleration)
• high dynamics:
step frequencies up to 300kHz
• 1.8µs step pulse length
and step to direction delay
SOFTWARE • stand-alone operation using TMCL
or remote controlled operation
• PC-based application development
software TMCL-IDE included
OTHER • 68 pin connector carries all signals
• RoHS compliant
• size: 80 x 50 mm²
ORDER CODE
TMCM-342 (-option)
Related products:
OPTIONS
H
V
DESCRIPTION
3-axis step / direction controller module
BB-302, BB-323-02, TMCM-EVAL, TMCM driver with step / direction input
Horizontal pin connector (standard)
Vertical pin connector (on request)
www.trinamic.com – for detailed information and datasheets
83