THL10 Datasheet, PDF (3/4 Pages) TRACO Electronic AG – DC/DC Converters

DC/DC Converters
THL 10 Series
10 Watt
General Specifications
Temperature ranges
– Operating without heat sink –40°C to +80°C (with derating)
– Operating with heat sink –40°C to +85°C (with derating)
– Case temperature +100°C max.
– Storage –50°C to +125°C
Power derating
– Operating without heat sink 2.5 %/K above +60°C
– Operating with heat sink 3.5 %/K above +70°C
Humidity (non condensing) 95 % rel H max.
Reliability, calculated MTBF (MIL-HDBK-217F, at +25°C, ground benign) tbd
Isolation voltage (60 sec.) – Input/Output 1’500 VDC
Isolation capacitance
– Input/Output 2000 pF max.
Isolation resistance
– Input/Output (500 VDC) >1’000 MOhm
Switching frequency (fixed) 300 kHz typ. (pulse width modulation PWM)
Altitude during operation 5‘000 m max. (16‘400 ft) approved
Safety standards UL/cUL 60950-1, IEC/EN 60950-1
– Certification documents (pending) www.tracopower.com/overview/thl10
Environmental compliance – Reach www.tracopower.com/overview/thl10
– RoHS RoHS directive 2011/65/EU
Physical Specifications
Casing material metal
Baseplate non conductive FR4
Potting material epoxy (UL 94V-0 rated)
Pin material tinned copper
Weight 15 g (0.53oz)
Soldering temperature max. +260°C / 10sec.
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
http://www.tracopower.com
Page 3 of 4