THB6 Datasheet, PDF (3/3 Pages) TRACO Electronic AG – DC/DC Converters

DC/DC Converters
THB 6 Series
6 Watt
General Specifications
Temperature ranges
– Operating –40°C to +71°C
– Case +95°C max.
– Storage –40°C to +125°C
Derating 3.0 %/K above 60°C
Humidity (non condensing) 95 % rel H max.
Temperature coefficient ±0.02 %/K typ.
Reliability, calculated MTBF (MIL-HDBK-217F at 25°C, ground benign) >700’000 h
Switching frequency 150 kHz typ. (puls width modulation)
Altitude during operation up to 5‘000 m (16‘400 ft) approved
Environmental compliance – Reach www.tracopower.com/products/thb6-reach.pdf
– RoHS RoHS directive 2011/65/EU
Physical Specifications
Casing material non conductive plastic (UL 94V-0-rated)
Potting material silicon TSE 3331 (UL 94V-0-rated)
Weight 18 g (0.63 oz)
Soldering temperature max. 265°C / 10 sec.
Application note : www.tracopower.com/products/thb6-application.pdf
- The component is not be used in an oxygen rich environment.
- The component is not to be used in conjunction with flammable anaesthetics and agents.
- The component has to be disposed appropriately. Please refer to local regulations (Waste Electrical and Electronic Equipment).
- A modification of the component is not allowed.
Outline Dimensions
31.8 (1.25)
2.54
(0.1)
20.32 (0.8)
2x2.54
(2x0.1)
2.0
(0.08)
1
24 23
Bottom view
11 12
15 13
Pin-Out
Pin
Single
1
+Vin (Vcc)
11
No pin
Dual
+Vin (Vcc)
Common
12
–Vout
13
+Vout
15
No pin
23 –Vin (GND)
24 –Vin (GND)
No pin
–Vout
+Vout
–Vin (GND)
–Vin (GND)
Dimensions in [mm], () = Inch
Pin diameter ø 0.6 ±0.05 (0.024 ±0.002)
Tolerances ±0.25 (±0.01)
Pin pich tolerances ±0.13 (±0.005)
Specifications can be changed without notice! Make sure you are using the latest documentation, downloadable at www.tracopower.com
www.tracopower.com
Rev. .May 06, 2013
Page 3 of 3