TEN30WI Datasheet, PDF (3/4 Pages) TRACO Electronic AG – DC/DC Converters

DC/DC Converters
TEN 30WI
30 Watt
General Specifications
Temperature ranges
– Operating –40°C to +85°C
– Case temperature +100°C max.
– Storage –55°C to +105°C
Thermal impedance
– with heat-sink TEN-HS2 8.24 K/Watt
– without heat-sink 10 K/Watt
Derating www.tracopower.com/products/ten30wi-derating.pdf
Humidity (non condensing) 95 % rel H max.
Reliability, calculated MTBF (MIL-HDBK-217F, at +25°C, ground benign) >350’000 h
Isolation voltage (60sec.) – Input / Output 1‘500 VDC
Isolation resistance
– Input / Output >1‘000 M Ohm
Isolation capacitance
– Input / Output 1000 pF max.
Remote On/Off
– On: 3.5 ... 12 VDC or open circuit.
– Off: 0 ... 1.2 VDC or short circuit pin 3 and pin 2
– Off idle current: 3 mA typ.
Switching frequency 300 kHz typ. (pulse width modulation PWM)
Vibration 10–55 Hz, 2G, 30 minutes along X,Y,Z
Safety standards UL 60950, IEC/EN 60950, compliance
up to 60 VDC input voltage (SELV limit)
Safety approvals
– UL/cUL www.ul.com > UL File no.: e188913
Environmental compliance – Reach www.tracopower.com/products/ten30wi-reach.pdf
– RoHS RoHS directive 2002/95/EC
Note 1:
In order to meet conducted emissions EN55022-A and EN55011-A a capacitor between +Vin and -Vin has to be installed. The capacitor
should be capable to handle 1 A ripple current. A suggestion is KMF Series of Nippon chemi-con, 220µF/100V, ESR 90mOhm.
Output Voltage Adjustment
Trim up
Trim
Ru
- Vout
Trim down ^+Vout
Rd
Trim
Ru [kohm]*
output
+5%
+10%
1.8V 2.5V 3.3V 5.0V
1.2 4.3 6.8 4.7
0.068 0.82 1.5 0.56
output
+5%
+10%
12V 15V ±12V ±15V
47 47 27 33
8.2 6.8 2.2 2.7
Ru [kohm]*
output 1.8V
–5%
1.8
–10%
0.1
2.5V
6.8
0.82
3.3V
8.2
0.68
5.0V
5.6
0.68
output
–5%
–10%
12V 15V ±12V ±15V
56 56 33 39
5.6 2.2 2.7 3.3
*approximate values
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
http://www.tracopower.com
Page 3 of 4