TEN30-2408WI Datasheet, PDF (3/7 Pages) TRACO Electronic AG – DC/DC Converters - TEN 30WI Series, 30 Watt

General Specifications
Temperature ranges
– Operating
– Case temperature
– Storage
Thermal impedance
– with heat-sink TEN-HS2
– without heat-sink
Derating
Humidity (non condensing)
Reliability, calculated MTBF (MIL-HDBK-217 E)
Isolation (Input/Output)
– Voltage
– Capacity
– Resistance
Remote On/Off
– ON:
– OFF:
– OFF idle current:
Switching frequency
Vibration
Safety standards
Safety approvals
DC/DC Converters
TEN 30WI
30 Watt
– 40 °C ... + 85°C
+ 100 °C max.
– 55 °C ... + 105 °C
8.24 K /watt
10 K /watt
see graphs on page 4 to 6
95 % rel H max.
>350’000 h @ + 25°C
1‘500 VDC
1000 pF max.
>1‘000 M Ohm
3.5 ... 12 VDC or open circuit.
0 ... 1.2 VDC or short circuit pin 3 and pin 2
3 mA typ.
300 kHz typ. (pulse width modulation PWM)
10-55Hz, 2G, 30 minutes along X,Y,Z
UL 60950, EN 60950, IEC 60950 Compliance
up to 60 VDC input voltage (SELV limit)
UL /cUL File E188913
Note 1:
In order to meet conducted emissions EN55022-A and EN55011-A a capacitor between +Vin and -Vin has to be installed. The capacitor
should be capable to handle 1 A ripple current. A suggestion is KMF Series of Nippon chemi-con, 220µF/100V, ESR 90mOhm.
Output Voltage Adjustment
Trim up
Trim
Ru
- Vout
Trim down ^+Vout
Rd
Trim
Ru [kohm]*
output
+5%
+10%
1.8V 2.5V
1.2 4.3
0.068 0.82
3.3V
6.8
1.5
5V
4.7
0.56
output
+5%
+10%
12V 15V ±12V ±15V
47 47 27 33
8.2 6.8 2.2 2.7
Ru [kohm]*
output
–5%
–10%
1.8V 2.5V 3.3V 5V
1.8 6.8 8.2 5.6
0.1 0.82 0.68 0.68
output
–5%
–10%
12V 15V ±12V ±15V
56 56 33 39
5.6 2.2 2.7 3.3
*approximate values
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
http://www.tracopower.com
Page 3 of 7