TSI10N Datasheet, PDF (2/4 Pages) TRACO Electronic AG – DC/DC Converter - TSI-10N Series 10 Watt

DC/DC Converter
TSI-10N Series 10 Watt
Input Specifications
Input current
(no load / full load)
TSI 10N-0510
TSI 10N-1211
TSI 10-N2410
TSI 10N-2411
21mA / 1435 mA typ.
27 mA / 895 mA typ.
45 mA / 330 mA typ.
45 mA / 485 mA typ.
Surge voltage (1 sec max.) 5 Vin models
12 Vin models
24 Vin models
16 V max.
25 V max.
30 V max.
Stand-by current
Output Specifications
Voltage adjustment
TSI 10N-0510 & TSI 10N-2410
TSI 10N-1211 & TSI 10N-2411
100 µA typ.
+1.8 VDC to +3.3 VDC
+3.0 VDC to +5.0 VDC
Regulation – Input variation
– Load variation 10 – 100 %
0.5 %
< 1.5 %
Ripple and noise (20 MHz Bandwidth)
50 mVpk-pk max. (with 2.2µF capacitor
on output)
Transient response time (50% Load change)
100 µsec typ.
Temperature coefficient
± 0.02 % / °C
Short circuit protection
indefinite foldback
Remote ON/OFF control
General Specifications
Temperature ranges – Operating
– Storage
ON=Pin 1 (ON/OFF Pin) to pin 3 (GND) open (3 – 5 VDC)
OFF=Pin 1 (ON/OFF Pin) to pin 3 (GND) short ( – 0.3 – 1.2 VDC)
– 25 °C ... + 70 °C
– 25 °C ... +125 °C
Humidity (non condensing)
95 % rel H max.
Reliability, calculated MTBF (MIL-HDBK-217 E)
>1’500’000 h @ 25 °C
Isolation Input/Output
none
Switching frequency
Physical Specifications
Vibration (IEC 60068-3-6)
300 kHz typ. (PWM modulation)
5 to 10 Hz amplitude 10 mm pk-pk
10 to 55 Hz acceleration 2 G
Shock (IEC 6068-2-27)
acceleration 20 G max. time 11 ms
Package weight
4 g (0.14 oz)
Soldering temperature
235°C max. / 10 sec.
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
www.tracopower.com
Page 2