TSI-24-50S3R0P Datasheet, PDF (2/4 Pages) TRACO Electronic AG – DC/DC Converter

DC/DC Converter
TSI-24 Series
15 Watt
Input Specifications
Input current (no load)
Input current (at full load)
Stand-by current
Output Specifications
Output voltage tolerance
Output voltage adjustment
Output voltage selection
Regulation – Input variation
– Load variation 0 – 100 %
Ripple and noise (20 MHz Bandwidth)
Transient response time
(with 220 µF output cap.)
Temperature coefficient
Short circuit protection
Capacitive load
Remote ON/OFF control
General Specifications
Temperature ranges – Operating
– Storage
Derating above 50 °C
Humidity (non condensing)
Reliability, calculated MTBF (MIL-HDBK-217 F)
Isolation Input/Output
Switching frequency
Physical Specifications
Vibration
Shock
Package weight
Soldering temperature
1 mA max.
1350 mA max. (12 Vin)
100 µA typ
+1.2 Vout
+3.3 Vout
+5.0 Vout
± 3.0 %
+1.2 VDC to +5.1 VDC
V.ADJ (pin 14) link wire to
+Vout (pin 17,18)
V.ADJ (pin 14) = open
VADJ (pin 14) connected via
20 kOhm resistor to +Vout
(pin 17,18)
± 0.3 %
< 3.0 %
35 mVpk-pk typ.
50 % Load change:
Vout over-/undershoot:
80 µsec typ.
70 mV typ.
± 0.01 % / °C
>105% constant current
20’000 µF
ON = Pin 5 (ON/OFF Pin) to pin 4 (GND) open
OFF = Pin 5 (ON/OFF Pin) to pin 4 (GND) short
– 10 °C ... +71 °C
– 25 °C ... +85 °C
3 % / °C
30 – 95 % rel H
>350’000 h at 40 °C
none
150 kHz typ. (PWM modulation)
5 to 10 Hz amplitude 10 mm pk-pk
10 to 55 Hz acceleration 2 G
acceleration 20 G max. time 11 ms
13 g (0.46 oz)
max. 260°C max. / 10 sec.
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
www.tracopower.com
Page 2