TES2-0511 Datasheet, PDF (2/4 Pages) TRACO Electronic AG – DC/DC Converter

Input Specifications
Input current no load /full load
5 Vin models
12 Vin models
24 Vin models
48 Vin models
Surge voltage (1 sec. max.)
5 Vin models
12 Vin models
24 Vin models
48 Vin models
Reverse voltage protection
Input Filter
Output Specifications
Voltage set accuracy
Regulation
– Input variation Vin min. to Vin max.
– Load variation 10 – 100 %
– single output models
– dual output models balanced load
Ripple and noise (20 MHz Bandwidth)
Temperature coefficient
Output current limitation
Short circuit protection
Capacitive load – single output models
– dual output models
General Specifications
Temperature ranges
– Operating
– Case temperature
– Storage
Derating
Humidity (non condensing)
Reliability, calculated MTBF (MIL-HDBK-217 E)
Isolation voltage
Input/Output
Isolation capacity
Input/Output
Isolation resistance Input/Output (500 VDC)
Switching frequency
DC/DC Converter
TES 2 Series
2 Watt
80 mA / 665 mA typ.
35 mA / 280 mA typ.
17 mA / 140 mA typ.
10 mA / 70 mA typ.
7.5 VDC max.
15 VDC max.
30 VDC max.
55 VDC max.
500 mA max.
Pi-Filter
±3%
± 0.3 % max.
± 0.5 % max.
± 3 % max.
50 mVpk-pk max.
± 0.02 % / °C
>120 % of Iout max., constant current
indefinite (automatic recovery)
470 µF max.
220 µF max.
– 40 °C ... + 60 °C (no derating)
+ 95 °C max.
– 40 °C ... + 125 °C
2.9% / °C above 60 °C
95 % rel H max.
>800’000h @ + 25 °C
1’000VDC
100 pF typ.
> 1‘000 M Ohm
80 KHz typ. (depending on load)
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
www.tracopower.com
Page 2