THP3 Datasheet, PDF (3/3 Pages) TRACO Electronic AG – DC/DC Converter - THP 3 Series 3 Watt

DC/DC Converters
THP 3 Series
3 Watt
General Specifications
Temperature ranges
– Operating –40°C to +85°C
– Casing +95°C max.
– Storage –40°C to +125°C
Derating 3.3 %/K above +70°C
Humidity (non condensing) 95 % rel H max.
Reliability, calculated MTBF (MIL-HDBK-217F, at +25°C ground benign) >1 Mio. h
Switching frequency 150 kHz typ. (puls width modulation)
Casing material non conductive plastic (UL 94V-0-rated)
Potting material Silicon TSE 3331 (UL 94V-0-rated)
Weight 16.2 g (0.57 oz)
Soldering temperature max. 265°C / 10 sec.
Altitude during operation up to 5‘000 m (16‘400 ft) approved
Environmental compliance – Reach www.tracopower.com/products/thp3-reach.pdf
– RoHS RoHS directive 2011/65/EU
Application note: www.tracopower.com/products/thp3-application.pdf
- The component is not be used in an oxygen rich environment.
- The component is not to be used in conjunction with flammable anaesthetics and agents.
- The component has to be disposed appropriately. Please refer to local regulations (Waste Electrical and Electronic Equipment).
- A modification of the component is not allowed.
Outline Dimensions
31.8 (1.25)
2.54
(0.1)
20.32 (0.8)
2x2.54
(2x0.1)
2.0
(0.08)
1
24 23
Bottom view
11 12
15 13
Pin-Out
Pin
Single
1
+Vin (Vcc)
11
No pin
Dual
+Vin (Vcc)
Common
12
–Vout
13
+Vout
15
No pin
23 –Vin (GND)
24 –Vin (GND)
No pin
–Vout
+Vout
–Vin (GND)
–Vin (GND)
Dimensions in [mm], () = Inch
Pin diameter ø 0.6 ±0.05 (0.024 ±0.002)
Tolerances ±0.5 (±0.02)
Pin pich tolerances ±0.2 (±0.01)
Specifications can be changed any time without notice.
Jenatschstrasse 1 · CH-8002 Zurich · Switzerland
Tel. [phone] · Fax [phone] · [e-mail] · www.tracopower.com
Rev. 10/12
Page 3 of 3